Is this game still getting updates? Things seem unbalanced.
I recently got the game this weekend, and have been enjoying it. However, the most efficient way to build seems to be more or less the same on every map. So, I just place dispensaries for every dish. I try to change things up, but it's always worse. The item that would seemingly be good at feeding multiple lines while saving energy, aka the splitter, seems to be quite terrible.
A dispenser is 1500 watts. Two is 3kwatts. A dispenser and a splitter is 2300kwatts.
So, I can pump out over DOUBLE the food for 3kwatts, or I can do half as much for 2300 Kwatts. And it's not even actually double, because you can shut the dispensers down when they're not needed.
In fact, if I could figure out how to use that computer, it would take far less power to run 2 dispensaries. Even with the order reader, it's probably near equal.
And if you were limited by space, you could just use a robot arm if you really had to.
Posted Aug 31, 2021, 9:29 PM UTC
Interestingly, the high speed dispenser is more power efficient than the regular dispenser. A regular dispenser uses 1500 watts to dispense an ingredient in 5 seconds. The high speed dispenser only uses 1200 watts to dispense an ingredient in 5 seconds.
I've tried to find a legit usage for the splitter, but I just can't. It's too specialized to make it useable in a bunch of different situations, and it's too imprecise to make sure the ingredients go exactly where you want. And when you use the splitter with one dispenser, you'll likely have to have a bunch more conveyor belts to get both ingredients where they need to be. By this point, it's far easier to use two dispensers.
The splitter came handy when I was using it in a tight space, but it wasn't really efficient and I'm just 4 days into this game, so I don't know much
I’ve used the splitter exactly two times.
There’s a level that makes a hot dog sampler where the component meals are a hot dog, a cheesy dog, and some other type of hot dog. All three component meals need 1x hot dog and 1x bun. For the hot dogs, I made a dispenser dispense 3x hot dogs onto a splitter in a 1:2 ratio so one hot dog went to the left for every two that went to the right. The right path then lead to a second splitter that split every two hot dogs evenly so half went to the left of the second splitter and half to the right. Then each hot dog is fed towards its own assembler which means you have one dispenser working for three different assemblers. Then I did the same with the hot dog buns.
I had a different level where all ingredients were pushed towards the assembler and I only had one dumb arm feeding all the ingredients into the assembler. The ingredients were backing up because the dumb arm wasn’t fast enough so I used a splitter to split half the ingredients to the left path and half to the right. Each arm of the splitter paths went to a dumb arm and each dumb arm fed the same assembler. It worked but then I found that the splitter moves slower than a regular conveyor belt so it wasn’t as effective a solution as it could’ve been.