Use over-the-range microwave on a table during reno?

We're about to start a kitchen reno and we'd like to be able to use our microwave to cook/reheat meals while we have no kitchen. It's an over-the-range microwave (which we're keeping in our new kitchen). The plan is to just put it on a table in another room temporarily. Are there any safety (or other) concerns with using it this way? The bottom isn't totally flat, it looks like, so we'd probably have to put a short 2x4 on the left and right sides it would sit upon.

Posted Sep 16, 2021, 8:58 PM UTC

314
sbNXBbcUaDQfHLVUeyLx•

i wouldnt worry about it if its on the 2x4s. itll get enough airflow.

5
1thatisnttaken•

Make sure no one accidentally turns the surface light on and forgets about it.

Source: oops 😣

3
Backlash27OP•

Oof, good call. I can put a piece of post-it over that button or something.

1
1thatisnttaken•

My best advice is to unplug it after each and every use. Make that common practice.

3
nclark8200•

Or remove the bulb if it’s easily accessible.

2
Backlash27OP•

Oh, it actually is!

1
kixio•

This was my advice too. Also sourced from an oops and a decent burn mark on the new living room flooring.

1
[deleted]•

it will work on any flat surface just dont take it into the shower or bathtub with you!

2
False-Flight•

You may be better off just buying a used microwave from Craiglist or similar, that way the over-the-range one can stay with the rest of the appliances. Presumably at some point during the reno you are going to need to have it in place to instal the wiring, duct work, etc. right?

1
Backlash27OP•

My understanding of the schedule is that the appliance re-install is the last step. Also, it's a basic over the range model that just plugs into an outlet in the cabinet that it's hanging under, and it doesn't connect to any duct work, just vents back into the room (if you even use the vent, which we generally don't).

1
False-Flight•

Fair enough. Mine is hardwired and has a duct for the exhaust so it's a little more involved. Even still, for $50 you could get a used one and not have to worry about balancing yours on a scrap of wood, then sell it for $50 when the reno is done.

1
Backlash27OP•

Fair enough. I'll look into it.

1
ZipperJJ•

I just had my kitchen redone. They didn’t put up the microwave until the absolute last day. If there’s a vent the microwave will come with a template or the contractor will make one. The wiring is literally just a plug that has enough slack regardless of where on the appliance the plug is.

1
decaturbob•
  • on spacers will be ok
1