r/3Dprinting•
rob64

Last year, because of Covid, our wedding had to be attended mostly over Zoom, so I decided to print some challenge coins for the few people who could attend in person. I embedded a large washer in each, to give it some heft.

Image
imgur.com/a/lR4IBh3
imgur.com

Posted Sep 19, 2021, 2:01 PM UTC

503

Looks good! They have metal infused filament available for weight or strength/conductivity. But shit is like a 100$ a roll. Lol

2
rob64OP•

Yeah. I figured I wasn't going to pretend it wasn't plastic, but it did feel odd being light.

2
[deleted]•

[deleted]

1
rob64OP•

Huh. I looked into it at the time and it seemed prohibitively expensive. But then again, I didn't look very hard. Ah well, it was a fun project to figure out.

1
[deleted]•

[deleted]

1