r/Optics•
dynode

Coupling single mode to multimode fiber (fancy detector)

I have some older, very fast fiber coupled detectors (50+GHz). Unfortunately, they have multimode fiber inputs (50µm). I would like to use them to measure the performance of a fiber laser, which uses standard telecom single mode fibers.

I think I understand the caveats of coupling a multimode to single mode fiber. I'm curious what the implications might be to go in the other direction.

Is there some efficiency caveat? Any tricks to try to coax my fusion splicer to make this joint? Should I try to couple it using connectors?

Posted Sep 20, 2021, 4:18 AM UTC

33
Dark_Sponge•

SM to MM is usually the easier case to analyze. You should have near perfect coupling of power since the SM core is so much smaller (~9 um). MM to SM loses power roughly equal to the core area ratio, and this will vary depending on the exact mode structure of the light (and would jump around as you bend the fiber, or with thermal expansion, yay).

I've actually done this before on a fusion splicer. I just stuck a MM and SM fiber into it, set it to "auto", and was mostly surprised when it worked the first try.

4
dynodeOP•

Much thanks, I’ll give it a go with my splicer.

1
davep314•

As long as you don’t have a long length of MM fibre and it’s relatively straight and you don’t touch it, (minimising bend loss in any excited higher order modes) then you should get relatively accurate power measurements.

2