yesidohavethat•

She wanted this. She is happy now. What parts did you use for the disc conversion?

3
esdan06OP•

I pulled zj backing plates and calipers from the junkyard. I got Timken bearings, part number SET 10 from rock auto. Tried out some power stop evolution geomet coated rotors and ceramic pads from rockauto. When you go from drum to disc on a dana 44 you have to switch the retainer plates on the axles from the flush ones to part number 5083678aa. Got those from ebay but the dealer could get them next day for the same price too. The ebrake cables don't attach but I got these adapters for my XJ when I did that swap and I ordered a set to get my ebrake to work https://www.theflopshopoffroad.com/products/ford-8-8-swap-e-brake-cable-adapters

3
yesidohavethat•

Thank you

3
esdan06OP•

https://jeepspecs.com/tj-generation/disc-brake-conversion/

If you want a write up to go by. Only differences on mine is that I just bent the hard lines instead of using the currie kit and the backing plate on the 96-98 zj comes riveted to the dust shield so it's all one piece. You can use a dremel and a couple grinding stone bits to widen the opening for the axle. It's a good idea to pickup some new bleeder screws ahead of time in case some are seized and you have to visegrip them off and replace them

2
[deleted]•

[deleted]

1