HezMania•

Honestly, from my experience, it depends on a few things. If you print a lot of smaller things and use a platform, you can probably get quite a few more prints out of this. I didn't see significant failures until I had actual dents in mine. I'm talking, hail damage type of dents.

If you are doing clear prints -- those scratches might make some interesting artifacts. The print may be successful but the finish will be tarnished. If you paint all of your figures, this probably wouldn't be an issue and you could get away with not replacing it.

The only time when I would suggest you immediately replace it would be if its leaking, or the dent is lowered instead of raised. By lowered, I mean the dent is in the direction of the LCD screen. This could cause damage to your LCD screen (trust me on this one).

4
KillAllWraithsOP•

Thanks for the advice! There was a little dent in it that didn't come out in the picture so I changed it.

1
KillAllWraithsOP•

Hey all, pretty new to 3d printing, I've been learning a lot the last week. Firstly, never use a napkin for the FEP, which accounts for most of the scratches I think. I've since gotten Microfiber cloths and been taking proper care of it and have had several good prints since. I was cleaning it off and saving the resin and noticed how scratched up its gotten since.

Is this the usual amount you all let it get to before replacing or does it have some more printing left in it?

It's an elegoo mars 2 pro, if that has any bearing on the answers.

1
keyboredYTA10M Dual Remote Direct Drive, CR-10S H-Temp, Mars 2 Pro•

It's surely a bit scratched, but unless it has some indentations, I would keep it. In my experience, cleaning it properly with isopropyl alcool after each print helps a lot in terms of visibility. I also apply a dry PTFE coating on it. Helps moderately with scratches but a lot with layer detachment.

1
KillAllWraithsOP•

Thank you, I changed it because there was a little indentation. Here's to clearer printing.

2
AlexRed668•

I'd change it at this point. The clearer the FEP the better the print.

1