How thru axle standards work?
Hi, I am pondering how thru axle standard lengths work - like you get a wheel with axle 12x142 but your bike is using 12x165 axle. Now what? You add some "spacers" on axle so the wheel is not freemoving on axle or how is this done?
Thanks for clarification
Posted Dec 9, 2021, 7:24 AM UTC
The 142mm, or more currently 148mm boost, refers to the width between the end caps on the hub, and the internal width of the frame dropout. The axle bolt itself is a little longer to include space for the frame tubes so that the hub is actually secured in the frame.
In the same way a 15x110mm front hub could have an axle bolt approximately 140mm long.
so basicaly they say total length of axle instead of the width of hub?
from Basso website:
That's a really weird format, calling out the hub width is more common. But yes, they're using the axle bolt length in that case.
thats why I am asking, I live in illusion that axle is standardized at 100mm front and 142 rear so this took me by surprise. Thanks mate!
Hubs are standardized for width and axle diameter. The axles themselves are unique to the fork and the frame.
It's weird for Basso to call out the actual axle size. If/when you decide to replace a wheel you need to do that based on the hub size, not the axle. You'll use the same thru axle that comes with the bike.
Axle is for road/cross/gravel right now. Axles are standardized.
The bolt that skewers thru the axle vary widely.
No.
This sounds like gravel/cross/road so ignoring boost.
Axle with for front is 12x100.
Axle for rear is 12x142.
The skewer bolt has to be longer to fit through the fork ends. So if your front skewer, thru bolt, is listed as 125mm long, probably means your fork legs are (125-100mm) /2 thick. Roughly 12.4mm thick fork ends.
Depending on what your bike is made from. Carbon, steel, alloy endcaps embedded in the carbon. The end points may be thicker or thinner on different bikes.
There are also multiple different thread pitches. And conical vs flat.