Has anyone repaired the stereo jacks on a Hifiman Ananda or know where to find a teardown?

Hi All,
I am currently in a shitty position. I have a pair of ananda that i got about 16 months ago and just had a failure of one of the stereo jacks. I know its the stereo jack because i have inspected the unit and could find no other point of failure, such as the magnet or the traces.
After cotacting support they initially wanted to send me a pair of BNIB Ananda for $250+25S/H but i have a poroblem with paying that much when its a literal stereo jack failure. after escalating and letting them know how displeased i was that they coudl not repair my phones, they came back with a "DEAL" that they woudl pay the $21 shipping if i paied $1000 to upgrade to the arya stealth magnet... i just told them to piss off and how dare they ask me to spend that kind of money for a failed stereo jack.

SO, i was hoping someone in this community has done this repair or knows where to find a tear-down? I can figure it out myself if there is no resources but id like to make it easier on myself if possible!

Thanks for reading my rant!

Posted Dec 10, 2021, 6:52 AM UTC

109
[deleted]•

[deleted]

3
XelsOP•

I have a lot of soldering experience. I haven't ripped these apart yet, but my last pair (he-560) had trs jacks that they just didn't solder the r, hence using the term stereo. I just know from that repair they also potted the jacks in, which made it a nightmare. Also, sourcing a new jack to fit is going to be difficult, I imagine.

1
KingTheRing•

Just get some decent quality jacks from online store of your choice. Hifiman Ananda has removable cable so you could even just buy a Y shaped cable already premade?

But it's quite simple, at worst you'll have 3 wires. Use a multimeter to figure out where does the cable cut out - connect it over the ground and either L or R channel in continuity mode, then bend the cable along it's length until you hear the multimeter beeping cutting out (or starting to beep if it's completely disconnected)

Then cut it off a bit above that, strip the wires and solder the connector on. If I'm right, the two 3.5mm's should be mono even tho they look like stereo plugs, which means only 2 wires to solder.

Also, after a bit of googling, looks like your problem is quite common and replacement cables are available online

1
XelsOP•

It's not the cable that I need. It's the jack inside the headphone. I found some that look like they may fit Inside the cup. I just know last time I ripped apart some hifiman headphones the jacks were potted Into the cup so removing them damaged the body.

1
KingTheRing•

Oh that's crap. If it's potted you have no other choice but Dremel it out. I mean you could always drill a new hole but it's never going to be symmetrical with the other one. An idea that comes to mind is to convert the headphones to a single cable, you could wire the driver on the broken jack side to the other side?

I never owned hifiman headphones, so I'm not much help. Just thought your cable broke from how you phrased the original post, but I wish you all the best in fixing them.

1
mdnpascual•

hey dude, my Ananda just broke one of the earpads and was quoted the same price. What did you end up doing with it?

Did u end up disassembling it?

1
XelsOP•

After quite a long back and forth with them, i finally got them down another $40 or so and ended up just having them replaced. If i had more of a desktop tinkers setup (like a drill press and vise and shit) i would have attempted to replace the jack, but i did not want to ruin the phones so i opted for the replacement. ITs shitty... all because they chose to install a low quality jack and pot it in so even if you wanted to replace it you have to drill the old one out. >_<

1
mdnpascual•

Do you remember the timeline on how fast it went through?

Do you feel like they repaired it or gave u a new one?

1
XelsOP•

IT was different serial numbers and it was new looking but in a bubble wrap pouch, not a new box.

I sent my pair into their NY location and they received it in about 3 days, then they shipped out the new pair 2 days later and i had them less than a week after that, so all in all, about 2 weeks.

1
mdnpascual•

Thanks a lot for the info!

They also instructed me to send it to their NY location so this is really helpful.

1