The prints with the new board are deformed, any suggestions? (Black left 180°C, other two 200°C) (Blue=old board, Black=new board w/20%infil)
reddit.com/gallery/rm9v5vPosted Dec 22, 2021, 5:16 PM UTC
18
Posted Dec 22, 2021, 5:16 PM UTC
THats a lot of ellephants foot. Maybe try lowering the tempature?
It sure looks like it but that's just the brim bed adhesion, I didn't took it out properly.
Have you verified your part cooling fan is working? Looks all the world like it's just heat-related sag, which would either be as a result of you running too hot (which you say you've verified) or not getting enough cooling in.
I haven't ... and it isn't working 😅
The printer was super quiet and I didn't even suspect it 🤦
Thank you!
I'll have to invert the fan connectors.
Same nozzle for all prints. Nozzle .4, set to .2 in Cura.
Speed 50mm/s.
Tried new print with 40mm/s and 30% infil but it look alike the print on the top left.
Old board was Anet 1.7 mainboard (with marlin 1.1.x).
New board is MKS Robin E3D with TMC2209 (marlin 2.0.9.2, stealthchop always active, hybrid mode disabled)
Double checked if the thermistor setting was correct, it is.
Check your vrefs and calibrate your x,y,z steps might help some.
I would double down on checking the proper z steps. The board may be calibrated for a different lead screw and the z steps could be off.
Good calls, after measuring the new prints the Y and Z axis aren't well calibrated. Specially the Z being 0,64mm off.
I'll go test this changes.