Masking tape keeps pulling paint layers
Hi All,
I'm in need of help, I'm building a 3d printed model of plane my friend just got promoted to, but having absolutely no luck with the painting despite having successfully done a less detailed version of this process in the past.
My process so far:
-
Sand as much of the layer lines down, hit it with Rust-Oleum filler primer, sand that down apply more coats until I'm happy with the finish. cleaning the model each time.
-
airbrush on a coat of Vallejo acrylic white primer wait ~ 10 minutes before applying a second coat, repeat once more for a nice clean surface.
-
wait ~48 hours to cure.
-
mask using vinyl (I think low tack) automotive masking tape.
-
airbrush secondary color(also Vallejo acrylic ), with ~10 minutes between coats
-
remove masking as soon as the secondary color doesn't feel tacky
-
swear as the masking tape lifts the white primer all the way down to the filler primer. Lifted areas are not consistent and range from small ~1mm spots to ragged inch long areas.
-
give up and ask for help.
I've seen plenty of people suggesting clear coats between anything color to help secure the paint but I'm a bit concerned about the layer buildup hiding details on the model.
Any help you can offer would be greatly appreciated. In the meantime I'm going to go strip the paint of the model and reset for another attempt.
I thought I knew what I was doing well enough as I've done this process before but this model is kicking my butt.
Link to the 3 pictures I have the plane prior to any color applied.
Posted Dec 22, 2021, 5:48 PM UTC · edited