So I need to replace the shafts in my irons and need some help with the shaft length when looking at used pulled shafts

EQUIPMENT

I'm looking at some pulled shafts on ebay, and all of the lengths are laid out in the photos.

the 4 iron is listed at 37.25" without a club head, and the PW is listed at 34.5"

Are these around standard length for cut shafts or are they a little longer? I'd post the ebay link but I feel like that is an easy automod deletion.

Posted Jan 1, 2022, 4:47 AM UTC

26
jdbourgeois16•

Standard

4

You need to know the "bottom bore to ground" dimension of the heads you have. Add that to the shaft length to get the total length.

2
Logsmith•

Is there a place to find those measurements? Looking for my callaway rogue irons

1

Measure one of your clubs for total length, and then pull the shaft. Total length minus shaft length is bottom bore to ground. Most clubs are roughly 1-1/4" bore depth, so if you wanted to guess, I'd go by that.

1
jdbourgeois16•

Club head adds maybe .5-1.25 inches in length depending

1
DontGetTheShow~6 / Hershey, PA•

It’s hard to say. Iron heads can vary from model to model in terms of the length between where the shaft sits in the hosel and the ground. So it’s not possible to give an exact answer. Maybe you can try measure where in the hosel the end of the shaft will sit, then measure to the bottom of the club by the heel to see how much length “the iron head will add” to the shaft. It’s probably 0.5-1”. If you’re able to find some pulls that are a little longer, then that’s safest since you can always cut the butts down a little bit if they’re a touch too long.

1