Need Help Troubleshooting connection between LSI 9300-8e and DS4246

Solved

Hello. I am currently running TrueNAS on my r620 and can't seem to get any of my drives in my DS4246 to show up. I verified that my LSI 9300-8e adapter was showing up by using sas3flash -list and sas3flash -listall and made sure it was updated to the latest firmware. In terms of checking on the Disk-shelf, the HDDS are getting power I can hear them spin up and the LED light on the drive trays is light up. For the LEDS on the disk-shelf itself, from top to bottom, I have a solid green light and then no lights on the lower 2 LEDs. Since the Activity monitor isn't lit up I am assuming it isn't able to establish a link. I am thinking it might have something to do with the cable but I also might be going down the entirely wrong route. I am thinking this is as simple as I got the wrong cable...? If that is the case does anyone have a reputable Amazon Seller who is offering the cable I need? The weird thing is the cable I am using easily fit, I didn't have to force it or anything and it felt like it clipped into place. I tried reseating the cable a couple of times and still couldn't get a link. Any suggestions on troubleshooting to determine the issue or if anyone else has faced a similar issue who was able to solve it? Any help or guidance would be much appreciated!

​

LSI Adapter:

Oracle Sun 7085208 SAS 9300-8e

​

Cable:

10Gtek SFF-8644 to SFF-8436 cable

HDDS:

Currently have 8TB HGST SAS Drives in the drive sleds.

Previously tried 200gb SAS SSDs and varying SATA HDDS

Posted Jan 5, 2022, 6:04 AM UTC · edited

15
dawsonkm2000•

10Gtek makes good cables. It also looks like the right one. 8644 to QSFP. I would make sure the QSFP part is plugged into the correct slot.

https://library.netapp.com/ecm/ecm_get_file/ECMM1280392

I needed to use a QSFP cable for mine but there are IOM's made for the dell version of the shelf that uses standard 8088 cable.

1
AppleTechyOP•

How would I got about checking if it is QSFP vs Sf-8088? It’s a netapp branded unit. I thought had it wired to the right port in the back but I’ll double check this evening

1
dawsonkm2000•

If it's netapp branded then it would be QSFP. (Side note that the connector for 8088 and Qsfp is the same!) You would see something on the IOM about dell if it was. Netapp build the shelves for dell. When I first tried to install it I had the cable in the wrong one. Hopefully that is what it is

1
AppleTechyOP•

Thanks. I figured out that I guess I hadn't inserted the cable all the way into the IOM. I had given up on it for a month or 2, sat back down and got it up and running in 2 minutes. Without your comment I probably would still be thinking it was an issue with the cable :)

1
dawsonkm2000•

Glad it worked out

1