r/fosscad•
uranium3d

Settings for braces?

Doing a brace print (sauerkraut by Middleton Made) and wondering if it would affect the strength much printing at 75-80% infill. Trying to knock down a little bit of time on the print, and the brace will only be on a 9mm. Any advice?

Posted Jan 6, 2022, 1:17 AM UTC

21
The_Dirty_Carl•

Perimeters are a lot more important for strength than infill. Think of structural steel - for stronger beams they make thicker walls, they don't fill it all up.

3