Functional high-speed, mid-runway taxiways
So one of my biggest gripes about the airport DLC is the inability to make mid-runway taxiways. Airplanes have to taxi all the way down to the end of the runway to exit. Not very realistic. And even if you do brute in a non-working taxiway, if you don't turn them off you get a network not connected thing. Annoying.
Well through dumb luck, I've made them work. Like literally I discovered this by accident because I made a parallel runway.
At minimum, you will need network multitool. I think you may also need findit2, moveit, and some way to turn on road anarchy.
So build a runway, ideally, right next to where you want your runway. Then, create a parallel runway. Delete the original runway -- for some reason, I cannot seem to delete the runway normally and need to use move-it. Then connect your taxiways -- I have only used find it2 taxiways due to the DLC taxiways slowing things down, I would be curious if this works with the DLC taxiways -- to the runway. The secret is to connect between nodes -- if you connect at a node, it will tell you you can't connect here. I believe I've had road anarchy on every time I've done this. Let it run a few cycles, and you'll start seeing airplanes on your other exits.
This has a few caveats:
If you connect taxiways that go toward the runways, airplanes will enter the runways there and take off. This can look odd, though shortened takeoffs aren't that weird as long as you set them where you need to be.
If you use outbound taxiways, airplanes will use them, even if they are far too close to where they landed. Annoying.
However, they work, and I'm sure people with more attention to detail than me can make them work better.
Posted Feb 2, 2022, 3:21 AM UTC
I don't even need them to be able to take off from the center of the runway, I just need them to be able to cross the runway(s).