97 Explorer serpentine belt jumping off track

Our 1997 Explorer with the 4.0 has a tendency to cause the serpentine belt to get off track by one groove when going from the water pump to the crank shaft. After the belt leaves the crank shaft and goes to the idler, it’s back on track. We replaced the tensioner pulley and it had no effect. Didn’t think it would but it was about due for replacement anyway. Is it possible for the water pump pulley to be causing the issue? Or maybe the crank shaft is misaligned? We can get it to start out lined up perfectly, but when revved up it will jump off track by one groove (closer to the motor). Any help appreciated!

Posted Mar 4, 2022, 5:43 AM UTC

14

Take a long straight edge to make sure all components are flush and correct the one that's out.

3
windirfullOP•

I will give that a try tonight, thank you!

1
AutoModeratorMOD•

Thank you for posting to AskMechanics, windirfull!

If you are asking a question please make sure to include any relevant info along with the following:

  • Year
  • Make/Model
  • Mileage
  • Engine size
  • Transmission Type (Automatic or Manual)

Redditors that have been verified will have a green background and an icon in their flair.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1
anotherbrokenauto•

Common for the outer ring with the serp belt grooves on the harmonic balancer to slip on the rubber damper ring. I've seen it come completely off before. Sometimes the ring will start to walk off and the first symptom is a belt concern like that. Pay close attention if the harmonic balancer belt grooves look out of alignment from the rest of the pulleys.

1