r/volt•
Lewl77

Stator Bearing - 2014-15?

Update: to answer the titular question for those searching in the future - yes, at least some 2014+ have had bearing problems. Though seems much less than 2013-.

--------------------------------------------------------------------------------------

Hi everyone,

Nearly-8-year volt here (2014), has treated me well over the years.

Recently noticed increased noise at the final moment of regen coming to a stop/starting up again from standstill. Could also be increased whine throughout the regen, but wind noise is masking it (whereas the final moments wind noise is basically zero)

Two questions

  1. I've known about the bearing issue for a few years and initial thoughts were 2014+ were "immune" with a redesign of the bearing cage. Recently have been searching a lot of posts, but everyone seems to be commonly 2012/2013. Not seeing any accounts for 2014 or 15. Anyone here experienced it? Maybe I'm just imaging things if no other 14's have had it.
  2. For those who had it, did you happen to notice this prior to it coming full-on? It's not like the videos I've previewed and a noticeable screaming Skil saw (yet), just increased regen noise.

I have just over a month of voltec warranty left, so I'll be driving with the radio off and listening like a hawk over the next few weeks to make sure it's not getting worse. Fortunately, some warm weather coming next week so I can open up the windows and have a good listen.

Could just be the cold weather and it goes away when it warms up. Though I can't say I've heard it like this before (could be my imagination amplifying things, knowing the clock is ticking on warranty)

Any experiences for >2013 appreciated! 🙂

Edit: forgot mileage. It is relatively low usage. Typically less than 10 000km/yr. Currently at 96k total, warranty is valid for another month or 160k (obviously time will come first).(Yes 8x10k is less than 96k. In 2017-18 I put an extra 17k driving coast to coast as a one-time deal)

Posted Mar 13, 2022, 10:22 PM UTC · edited

211
alaninsitges•

I have a 2012 Ampera that the bearing race was replaced on just recently. I drove it for two years before it got bad enough to spend the money on - I don't drive this car a whole lot recently, it was only maybe 10,000km. It was a VERY gradual increase from barely noticeable.

1
Lewl77OPVolt Owner (2014)•

Yeah that is one of my thoughts. If it will be several years, I likely may not need to replace it before the entire car is traded for something new.
But if it gets bad in the new few weeks it is my now-or-never situation to get it under warranty.

Mileage is a good point, I will add to the post, thanks.
I normally only drive less than 10k/year.

1
[deleted]•

Mid year 2013 and newer got the updated bearing. I did have the bearing replaced in my 2014 when it started sounding like a woodsaw at 110,000 miles, it cost $1700 and GM warrantied the replacement for 3 years or 30 k miles. I replaced it right after it started making noise, it's never a good thing when bearings go out, and that's an important one. I was still in the voltec warranty, but that didn't cover the bearing.

1
Lewl77OPVolt Owner (2014)•

I think your dealer screwed you, as the bulletin even lists EV warranty codes 😥
But good (or bad, I guess) to know that 2014s have had it too and it is something I should look out for..

1
[deleted]•

Voltec warranty ends at 100k in a non-CARB area. The noise wasn't as bad as the pre MY 2013 vids I looked up. I could have probably let it go for a while, but had it done anyway. I have 20k on the fix. Ed. I misspoke about being in warranty earlier

1
thnk_more•

Not sure what you are hearing but with the little bit that you drive and you said it goes away when warmed up, you might have some rust on your brake pads or other contamination.

The friction brakes generally don’t kick in until the last 5 mph or so IIRC, which sounds like the time you are describing.

Depending on where you live, the cool night temp and humidity at night can cause condensation on the heavy steel rotor and a little bit of rust, until the seasons change.

If it is kind of predictable, like first thing in the morning at the first couple of stops you hear it, you could shift into neutral before using the brakes. Then all your breaking is friction brakes.

If it is pads or rotors then it will be worse. If is related to regen then it should be silent.

1
Lewl77OPVolt Owner (2014)•

I'm well acquainted with brakes, I have braked in N to hear only pads (and not the noise) and I have regened to near-stop using L to replicate the noise without any pads at all.

I know it is regen noise, 100%.

2
thnk_more•

Bummer. I have a 2014 and was hoping we were immune to the stator bearing problem.

Hopefully, the noise something simpler than that.

1
No_Fill5174•

What kind of noise is this?

Is it a mechanical clank or a screech from the bearing?

1
Lewl77OPVolt Owner (2014)•

It is an elevated noise of the regen whirr, almost like blended with skil-saw style sounds.
However it's still quite faint, I might just be imagining it. I'm going to get access to another volt later this week to compare back-to-back and see if I'm losing it or not.

1
sasquatch_melee2012 Volt•

Anything is possible. Mine had to have the revised bearing put in twice by 45k miles. The 2nd dealer guessed it was done wrong the first time though.

1