r/WRX•
coderduck

1st manual, 2021 premium. Initial thoughts - fun and frustrating!

1st manual, 2021 premium. Initial thoughts - fun and frustrating!

Posted Mar 25, 2022, 12:53 AM UTC

15445
coderduckOP•

Fun because it’s my first performance sedan! Frustrating because my shifts are jerky as hell

28
TruckinUncleEdd•

Level off your revs when you upshift. What I mean is, back off the throttle a little, hold your rpm's there for a second, then shift. Progressive shifting helps to smooth things out also. Use fewer rpm's in the lower gears, and then increase your engine speed between upshifts. Maybe try your 1-2 shift at 2000 rpm's. Your 2-3 upshift at 2500. 3-4 upshift at 3000 revs, etc, etc. After you ace getting smooth shifts, then work on going fast! Hope this helps.

18
coderduckOP•

Thanks for the tips, will definitely try this out in my next session

2
WirelessTrees2020 WRX Magnetite Gray•

Try letting the clutch out much slower and smoother.

You won't cause extra wear on the clutch. It's meant to be slipped!

9
coderduckOP•

I have started doing this and definitely notice less jolt. Are you completely off the throttle while slowly clutching out?

5
surfmaster19 CBS WRX•

It honestly depends: downshifting, absolutely not, you in fact often want to rev up a little bit while shifting to a lower gear to match the engine speed to your target gear speed. Even when upshifting, you'll often want to be giving it a little bit of juice but if you're driving conservatively, you'll often be shifting into a very low rpm so you don't need to have the engine spinning too fast.

This becomes sort of natural as you drive, and I find it's actually counterproductive to try to think about doing it, as it comes easier eventually just as an almost unconscious action.

5
WirelessTrees2020 WRX Magnetite Gray•

No. I give a slight amount of gas consistent while slowly clutching out. I basically just rest my foot on the gas pedal.

You need to be giving a small amount of gas, and you need to be smooth on the clutch.

3
PMull_90•

One of the easier cars to learn on. You’ll pick it up quick!

4
[deleted]•

[deleted]

5
FreedomSoftware•

My dad told me when I first started driving manual, not every shift is going to be perfect. I sometimes fuck up real bad while shifting. I’ve been driving stick for 6 years.

3
luke649418 Wrx Stage 1+ Phatbotti•

It took me a while to get used to this clutch in this car. You have to let it out slower than any other manual ever LOL. You will get it though I promise. Aslo 1st to 2nd seems to be smoothest at like 3k right on the money or at like 1800. No in between.

3
isogreyTotaled 2021 Base•

It’s my fourth manual transmission car and my shifts were jerky for a while too. Just keep practicing. Search on here for some tips, lots of people have/had that issue.

20
coderduckOP•

Thanks y’all! Been reading a lot in this community and have gotten much valuable tips. I will say that since the start of learning stick, I appreciate how much more focused I am on the road. I find myself preemptively planning what to do for upcoming lights, stop signs, etc.

13
burgher892021 WRX•

It's scary how much modern cars can basically just let the driver be asleep at the wheel. I feel like my wife's Crosstrek is the perfect car for someone who wants to set off, zone out completely, and just arrive at their destination.

3
Big_Inflation_3716•

i would say turn off hill assist to make the experience smoother but since its your first manual maybe get used to launching on hills first

12
BossDRB'21 WRX Premium•

Hey, looks just like my car. Welcome friend! Let out of the clutch slowly in 2nd, shift around 2700 - 3000 rpm from second to third third and let it drop roughly 800 - 1000 rpm before letting the clutch bite. It'll become easier.

8
coderduckOP•

Thanks! Should there be a little throttle as I’m slowly clutching out and engaging into 2nd?

1
BossDRB'21 WRX Premium•

No, only slip the clutch with throttle in first.

Basically, at a stop, rev a tiny bit to <1500 rpm and begin letting the clutch out gently as you roll into the throttle slowly. Then shift into 2nd at roughly 3000rpm and let the revs drop with the clutch held in for a second, then slowly let out of the clutch. The rest of the shifting is quite smooth.

My first comment I meant to say 1st to 2nd, not 2nd to 3rd. Sorry about that.

3
coderduckOP•

Thanks for clarifying! Another technique to try out next session, hence the fun! 😁

2
tydadad•

My first one too you’ll get the hang of it soon

3
sickkruben•

Congrats man , welcome aboard 🤝✌🏻

3
USPS_ontime•

Just ride the clutch in a little longer if you can’t handle that jump. You made a good choice.

3
BallzarBig•

Yeeee! I got the same exact one, I too had slight shifting issues- especially with the stock tune. Ended up doing a stage 1+ and what a difference, the shifting/powerband is a lot smoother imo. But there's a price to doing this, there might be complications if and when you do a warranty claim through your dealer. Pay to pay but to me it's worth it when done right.

3
ItsElSavage2013 wrx hatch•

While youre learning it would help to read the manual and look at the recommended shift points in relation to your speed. Helped me out a bunch, just got my first manual a month ago and it feels second nature now.

3
burgher892021 WRX•

OP, you done the bite point exercise? Get her rolling from a stop on level without the gas pedal?

2
coderduckOP•

Yes, that was my week 1 in an empty parking lot

2
burgher892021 WRX•

That’s good, now apply that to all your shifts. That point doesn’t change from first to sixth. That point is where you need to start getting back on the gas. Take an extra second before you let off the clutch if your shifts are jerky, you’re likely trying to rush things.

3
coderduckOP•

Just tried this and the extra second helped! Now just need to understand how to apply this and do it faster. You’re right in that I’m definitely rushing things to try and keep up with daytime traffic.

2
burgher892021 WRX•

Slow is smooth, smooth is fast. Don’t get in your head, people aren’t as worried about how fast you set off as you are. As you get more familiar with it you’ll get faster at shifting without sacrificing smoothness.

2
IAmVerySuperCool•

I just acquired one recently, it’s also my first manual. I’ve only driven it twice yet, but I feel you

2
coderduckOP•

Congrats man. Hopefully more fun than frustrating as well for you 😀

2
IAmVerySuperCool•

3rd time driving it, I'm still stalling but at least now my shifts are smoother so I'm hopefull lol

1
idkmanporn•

Your issue may be timing your shifting. Take note to how long it takes the engine revs to fall to the appropriate rpm for the gear you are about to engage. This is something you will begin to notice naturally over time. You'll also start to notice how the speed at which the revs will drop will depend on how fast/slow the engine was spinning when the shift was initiated. For me, learning how to time my bite in and bite out moments helped minimize jerking while shifting.

2
syphon3980DMG 19 STi•

I've driven a few manuals in my time before I got my wrx (and now STI). I learned to drive an old miata as my first driving experience, then owned a Rx7FD when I lived in japan, and then drove my sister's 350z, and those were WAY easier to drive manual. The WRX/STi has been the most difficult manual transmission for me to drive. Hell I still make a mistake twice or so a year. If you can master this manual then you can drive just about anything. Congrats on joining the stick shift club; we are a dying breed

2
big2hundo'20 WRX PP Torqued Performance•

If you plan on doing any mods, I'd highly suggest the Group N transmission mount, and at a minimum a shift stop (Perrin or Cobb). The transmission mount will eliminate some of the jerkiness, and the shift stop will not only make shifting more enjoyable, but the improvement in accuracy when shifting will make your shifting flow more consistent, which should help with smoothness. Both are affordable parts that are pretty straight forward installs.

Congrats on the car!

2
Woozy1•

You'll get it, come with much practice. Not sure how fast you're shifting, maybe slow down your shifts a bit.

2
minecraftpro69x2013 WRX Hatchback•

the idea when learning manual is that it should take you 7 seconds to let out the clutch from neutral to first.

2
HelpDeskThisIsKyle21 DGM WRX •

Having an axle back exhaust helps ya hear the engine, gives you a better idea of when to shift. Eventually it'll be second nature. Welcome!

2
coderduckOP•

Yes, my auto detailer suggested this for better audible feedback. Though since this is my first manual performance car, it already sounds plenty loud compared to my suv 😀

2
HelpDeskThisIsKyle21 DGM WRX •

Agreed! I was pleasantly surprised by the sound of a stock cold start when I got mine. It will also be all that more rewarding to hear clean shifts with am aftermarket exhaust.

2
CreativeUserNme‘21 WRX Premium •

I’m 5 months in and I still struggle sometimes. Same year and trim level just WRB instead of gray :). You’ll have good days and bad days for sure. Once you get better it’s SO much more fun to drive! Another added bonus is that every other car you drive will be a walk in the park! I’ve driven 6-7 other manual cars since I’ve learned on mine and everything else is incredibly easy haha

2
fnwzrd•

I learned manual on my 2015 Wrx. Took me about 5 days getting yelled at by my dad to release the clutch to finally get it lol. Probably took about another month to perfect it.

2