Passenger window stuck down even after replacing motor and regulator.
As mentioned, the window will not go up. If I keep the key in the ignition, the window motor will get very hot. This happened with the 2 new motors I’ve tested.
What I’ve tried:
- window reset.
- slamming the door while holding up on the switch.
- Checking if the window lock was on.
- Turing the key in the door lock to roll it up.
- replacing the motor and regulator.
I’m at a loss of what to do. The power locks and lights work on the switches so I’m assuming the whole thing is in working order.
Also, if I plug in the motor and don’t attach it to the regulator, the square socket on the motor continuously rotates.
UPDATE: I found the cause of the issue. The problem is the small plastic part on the switch that makes contact with another small plastic switch just beneath the circuit board. I broke a part of the plastic off when applying new trim.
I put a flat head screwdriver in the track where the switch would be and moved it back and forth. The motor then stopped and performed normally. Guess I’ll be returning the regulator and motor. u/user350z
Posted Mar 30, 2022, 7:47 PM UTC · edited
If the motor is getting hot whenever the keys on, then it most likely has power being supplied to it constantly. Sounds like a switch, relay, or wiring problem.
Well.. I’ve disconnected the battery for the night in hopes that it’ll do something. If not I’ll have to take it to Nissan because electrical shit just isn’t my thing.