Was given an amp and head - any advice on how to clean it?

https://i.imgur.com/yxNBFLA.jpeg

This thing sounds amazing, but is quite dirty and smelly (cigarette smoke etc). Is there a safe way to clean it without damaging it?

Posted Apr 5, 2022, 6:46 PM UTC

1010
Tyrsonswood•

Dish detergent, some water, and a tooth brush for the tolex. Mix up a little dish soap and water in a small tin. Scrub small areas working up suds. Wipe off with a rag and go the the next spot. You may end up doing this a couple of times if it's really bad. Don't get anything overly wet and watch out for drips... don't want to get speakers or the amp chassis wet.

5
nullhed•

That's what I did with my Bassman. It took a few times going over it, but it's not sticky or smelly anymore. I made sure to work small areas at a time and immediately dry them.

I think you need a steamer for the grill cloth though.

3

Its hard to find musicians who dont smoke. I quit 5 years ago and stink when we're done jamming. My drummer starts drinking steel reserve and getting high at 10:00 in the morning. They tend to smoke a lot more cigs when they are playing. I never bothered trying to get the stink out of my amp because it will get right back in there next week. So maybe if it was a big concern of mine i might try spraying it with febreeze.

3
stateofidleness•

You can usually take the front baffle (as it’s called) off with screws from the inside of the cab. From there, you can either DIY a tolex replacement if you want, or maybe try steam cleaning it?

1
nowonmai•

The baffle is the board the speakers are mounted to.

1
thebeengrim•

Yes, but u/stateofidleness is saying you would remove the baffle and the speakers from the inside of the cab so you could clean or replace the front grill cloth, because the grill cloth does not appear to be removable from the front of the cab.

1
nowonmai•

I may have misinterpreted. My bad if so

1
2SJSlimOP•

I don't see an easy way to get it off... do I have to take the back panel off and pull everything out to get to it ?

1

I'd recommend you do yes. You can spot clean but with that level of age / dust the best way to go here is disassemble as far as you're comfortable then use a mild mix of dish soap and water. Like a cap of soap to 2 or 3 cups of water mixed well. Toothbrush or conventional brush.

Instead of a brush and tons of water it may be a better call to just use a soapy (wrung out) rag then wipe clean with another clean / wrung out damp with water rag.

The design may dictate how much has to be disassembled but at minimum remove the back cover and find the method to remove the grill. Hopefully speakers can stay in.

Depending on how robust the grill material is a steamer could be great. Being gentle is key. With the artificial more modern ones I have just used a brush and water in the past like the toilet just being gentle. Go light on water for that part and don't leave any standing. Particle board will suck it up - expand - and lost strength+not fit right. A steamer would avoid most of that risk.

1
[deleted]•

[deleted]

1
GuitarNerd234•

I used to have one of these! It was pretty neat. As far as cleaning goes there’s plenty of recommendations here. I’d take the front grill off and cut up a tyedye tapestry and make a new one for it.

As for tone, if you don’t intend to use the effects loop, for a tighter high gain sound people would put an extra patch cable/coupler in the loop jacks. It was a noticeable difference. If you do intend to use the FX loop… Line6 products go into them amazingly well!

1