Help me analyze my head shake incident this morning

So I had an experience with pretty bad head shake this morning. I was doing about 55mph around a gentle curve. I can't recall exactly but I couldn't have been leaned over more than 5-10degrees. The road was concrete, and I hit an uneven seam that threw my bike right into a head shake - enough to rip the handlebars out of my left hand. I was able to maintain a loose grip with my right hand to keep on the throttle and eventually road out of it after a few seconds.

Now, this isn't the first time I've experience head shake/tank slapper, but it's always been because of a problem with the bike (i.e. bad front tire) or me doing something stupid (coming down from a wheelie with the bars cocked). I've learned my lesson the hard way with those, so now I'm trying to figure out what went wrong here.

Tires: Seem fine. Plenty of tread. I'll check the tire pressure before I leave work today.

Suspension: The Street R comes with an adjustable suspension. I've played around with the compression and rebound settings, but never have set sag to my weight. Is this a potential issue?

Form: To be honest, I don't remember the details. I generally think I have pretty good form (correct body position, light grip on bars), but still it's possible I upset the bike with my form. Any ideas?

Road conditions: Caulk this up as just hitting a concrete road seam in just the right way to upset the bike?

Other: Any other ideas?

Posted May 22, 2012, 2:35 PM UTC

311
MotorcycleCKDucati GT1000•

When I first bought my Ducati, I experienced a little handlebar wobble as soon as I hit 100 mph. This was consistent until I eventually had the front tire replaced, and it mysteriously went away and has never returned.

Hitting the road seam could definitely be the culprit, but the shake should go away. I usually go right over things like that, because I know the bike will stay stable. It may be worth it to take it to the dealer and ask them to test it out. Headshake when coming off a wheelie or after the road seem a little normal, but not to the extent you describe. You should make sure it isn't going to present a safety issue.

1
metricbot•

100 mph = 160.93 km/h

4
thinkmcflyOP2009 Triumph Street Triple R | 2003 CBR600RR Track•

I've never had issues going over uneven surfaces until today. The bike has been inspected by the dealer for a "clicking" noise I heard - they regreased the head bearings and inspected the front end, saw no issues other than them being a little dry from the factory.

1
re-run78 CB750K, 84 VF700C, 06 fz6•

Do your tires have any cupping? It isn't always just pressure. Why style of tire do you have? Some may be more prone to instability. What is the rake of the forks? Bikes with short rake can be more prone to slapping. A steering damper helps with this. Check steering bearings, make sure they are not notched or dry.

1
thinkmcflyOP2009 Triumph Street Triple R | 2003 CBR600RR Track•

Tires show no signs of abnormal wear. They are stock Dunlop Qualifer tires. Rake / Trail: 24.3 deg. / 95.3mm. The Daytona as a more aggressive rake and a stock steering damper - Street Triple does not have the damper. The steering bearings have been inspected and regreased by the dealer a few thousand miles ago.

1
re-run78 CB750K, 84 VF700C, 06 fz6•

It may be a damper might be all you need. I have never been impressed with dunlop tires though, but they were on other bikes.

1
saneenoughAprilia RSV Mille R•

You would probably want a steering damper on a wheelie machine anyway, so I would suggest investing in one. Regardless of the aggravation, this would prevent it. See if you can get a scotts or a gpr to fit on your bike so you can have it for your next bike.

I know R6's had problems with head shakers when the rear tire was replaced but the front tire was left on to go another round (even though there was nothing wrong with the front tire that was being left on - not all of them, but I've seen it mentioned by some riders). Maybe there is something similar going on.

Tweaking with the front compression and rebound can really make a mess of things if you aren't 100% on what you are doing. Do you ever notice it being slightly easier to lean in one direction over another? It could be that your left and right fork settings are not identical and this can be an aggravating factor. First thing I do with every bike I buy is pay $40 to have my suspension set up by someone that is an expert at it. It makes an insane difference on the ride, and has safety benefits as well.

1
thinkmcflyOP2009 Triumph Street Triple R | 2003 CBR600RR Track•

Tire wear on front and back are pretty equal. I keep the burnouts to a minimum.

I'm pretty sure I adjusted the suspension correctly per the owners manual, but it's something I will need to double check. I can't say I've noticed the turn in being easier in one direction. I'd like to have someone help set up my suspension - where would someone go for that?

I've considered a steering damper in the past. I usually keep the front wheel on the ground, so I haven't been too concerned until now. Maybe I'll reconsider.

1
saneenoughAprilia RSV Mille R•

Even if you keep the front wheel down, the bike will get pretty light on the front wheel upon acceleration and even that can cause tank slapper if you hit a weird patch of road. I'm sure you know, but it's always good to keep your weight off the handle bars so the front wheel can correct itself. Steering dampers on a bike like the speed triple are always a good idea. The Ohlins dampers that look like the piece you see on screen doors are very effective (as long as they didn't come off a Kawasaki), and cheaper than the Scotts or GPR. I know they made one for my old Daytona 955i. Considering you have experienced a tank slapper on the bike, I would be rushing to go get a damper. Nothing will fuck up your day/life like a serious tank slapper at speed.

If you are in San Diego, I know a guy that does awesome suspension tuning. Otherwise, any shop really should be able to do it for you. I'm not sure if you have any track/performance oriented shops near you, those are the best ones to go to (basically any shop that will install and dyno tune a power commander for you will be able to get you set up). I wouldn't doubt if your Triumph dealer could do it for you as well. I wouldn't pay much over $40 for it. It will blow you away how much nicer your bike handles if you tell them to make it sporty.

Also, the wear will never be totally even between your front and rear. The rear will always end itself first. My rule of thumb is 1 front tire for every two rears.

1
Mirrory[Plano, TX] 2012 Street Triple R; 08 WR250X•

Concrete roads are the worst, especially with seams. I hit one on the 5 once doing about 80 and got thrown into a good 4-5 second tank slapper. Luckily I stayed in my lane. Right where the 805 north merges with the 5 north. Big black seam from an old onramp. Pavement height difference is probably 3-4 inches.

1
Bazzie09 Triumph Street Triple R•

Happens to me under heavy acelleration while leaning and riding over bumps aswell sometimes. Best to accellerate out of it or invest in a steering damper.

1