Looking for rare Manurhin MR73 part. Hand/Barrel lever
I need part 137 on this schematic. https://ic.pics.livejournal.com/larvatus/3533539/189664/189664_original.jpg
I actually have the newer version of this part (13701). Guessing someone tried replacing it with a newer version but it doesn't work. Every other trigger pull it jams. https://imthi.actioncom.fr/dbIMAGE/chapuisarmes/image/I_8EVVA_1542791804935.PDF
Posting in the off chance someone has the part I need and needs the part I have and wants to trade.
Thought about grinding this so it matches, but it can't be done. Too much mismatch. Any advice appreciated.
Posted Apr 20, 2022, 7:04 AM UTC
Oof, and I say that from experience.
I also had an MR that needed to be re-timed, and it was the older-style version, so the hands are no longer parts that can be ordered from Chapuis, and your odds of running across one on Ebay or any of the other parts suppliers is basically zero. There are essentially two ways to go.
Check out Hastings Distribution out of PA. They've long been the source of spare parts for Manurhin revolvers in the US, and they have months-long lead times, but if you order something they will eventually send it to you. According to Hastings, part of the problem could be due to the "cylinder lever pin" and have this to say: "Generation one uses a wire spring, which looks like a safety pin, to hold the cylinder lever pin in place. Generation two uses a flat spring to hold the cylinder lever pin in place. The cylinder lever pin for the first generation is no longer available. If you have to replace the cylinder lever pin for a generation one gun, you will need to replace the cylinder lever pin, the screw, and the side plate." Part of the issue might be the difference in diameter between the pin connecting the new style hand and the method in which it's secured. (More here, assuming you haven't already seen it: https://www.hastingsdistribution.com/index.php?pg=2&l=product_list&c=60)
Hopefully a really good gunsmith knows how to retime the thing and/or can custom fabricate a part. This is not a job for your good 'ol boy gunsmith around the corner. I would send out emails to Frank Glenn, Mike Heffron, Cylinder and Slide, Ten Ring Precision, and Alan Tanaka (this list is not exhaustive), and see if any one of them has experience re-timing an MR-73.