Unable to get a connection to TG784
Device: Thomson TG784
Firmware: openwrt-15.05.1-brcm63xx-generic-HomeHub2A-squashfs-cfe
I tried installing OpenWRT onto the router with initial success: everything up to and including the CFE page worked fine (!). However, after booting into OpenWRT, none of the interfaces seem to function. The LED blinking seems to indicate that the boot was fine (distinguishable fast and slow blinking depending on whether it is in failsafe mode or not), but I've had no luck connecting to the router in this state. I also don't have any way to interface with serial.
What I've tried:
- uninterrupted boot and failsafe
- setting static ip to 192.168.1.2 and 192.168.1.35
nmapping 192.168.1.1/24 (and /16) (+ 192.168.1.1 with-Pn)- using lede-17.01.5-brcm63xx-generic-HomeHub2A-squashfs-cfe (from here) instead (visually the same)
- all 4 ethernet ports and the WAN port
I also can't find the UDP broadcast during boot on any of the ports.
There is a possibly related forum post here, but with a newer version and slightly different model.
Posted May 17, 2022, 2:57 PM UTC
If it is unsupported , it is advisable to go back to stock firmware . Restart doing this after your modem is back online. I ADVISE you to abondon this unless you are an openwrt developer
This specific router fell out of use quite a while ago and I hope to utilize it as a receiver or something similar (not possible with the stock firmware AFAIK).
If you have any tips on what to modify in the source so that it could work, I'm willing to try to get this working for some more time.
EDIT: I should add: it seems that others have previously got it working based on e.g. the wiki page. I don't have much experience with reflashing firmware, but I expected there to be consistent results for the same device model (i.e. maybe I overlooked something that needs reconfiguring, which I couldn't see in the wiki).
EDIT 2: looking at the wiki page again - does "... with no network connectivity set up" refer to this exact state? I assumed it meant that the flashing itself could be done without connecting to the router (before flashing) this way.
Hello.
Like you, I had one of the laying around and decide to use it for something.
I flashed it with the latest version and had some degree of success.
It works but has no Ethernet connectivity.
I got it to work using the serial interface and then connecting to WIFI.
It seems to be a SPI configuration thing ... see https://forum.openwrt.org/t/bcm5325-switch-spi-on-bcm6358/85099
If somebody knows any solution, please advise.