Questions about LEDs

For my next build I want to do a soldered board based on the DZ60 V3. I plan on soldering in hot swap sockets for the in-switch-LEDs so I can change the color of them. The switches I plan on soldering directly.

I ordered a bunch of LEDs in all the colors I could find and found out there are roughly two groups: Those that use around 2V and those that use 3V.

My Questions:

  1. Which are are best suited for a keyboard?
  2. Can I mix and match? For example 2 V and 3 V on the same board or different colors?
  3. How are the LEDs wired up on a board? Is there some kind of LED driver or a resistor for each LED or for groups of LEDs?

https://preview.redd.it/1v6f6i25t9291.jpg?width=4000&format=pjpg&auto=webp&s=a13395ab1ab0e0b4b5a70ae895b08fae360aa577

Posted May 28, 2022, 7:42 PM UTC

01
_vastrox_keyboards.elmo.space•
  1. 1.8mm diodes work best in my experience since they have the least chance of creating any interference with the keycaps. the flat 2x3x4mm usually work fine as well though.
  2. yes doesn't matter. they might be different brightness though.
  3. the LEDs are wired in parallel in one circuit with a resistor for each LED already on the PCB. You can control the brightness of all LEDs at once but not individually.
1