Any benefit to resolutions higher than monitor’s “native” resolution?

Hi all, I am new to CRT gaming and am proud to own a dell e773c that I’ve used since childhood. I’ve recently used CRU to make the resolution higher, at 1440p. However, I’m not sure if this higher resolution actually makes a difference when it comes to CRTs. The highest supported resolution is only 1024p.

Tl;dr are resolutions higher than the native resolution actually displayed as is?

Posted Jun 21, 2022, 3:07 AM UTC

110
_RexDart•

Yes

3
Crest_Of_Hylia•

Running at a higher resolution than native is basically super sampling which is a type of anti aliasing making the image look better overall

2
DangerousCousinLaCie Electron22blueIV•

Yeah, you can hit 1536x1152 @ 60hz on that monitor. I don't think 1600x1200 is doable unless you reduce blanking lines which might warp geometry, you'll have to see.

Going beyond your monitor's dot pitch is useful for games where you are CPU limited or they have 60fps cap. As the other guy said, it's kind of an analog super sampling. A little bit of detail is lost behind the shadow mask, a little bit is blurred together, but it will still look better than lower resolutions.

If you're on a severely CPU limited game where you're doing 30 or 40fps on a strategy game or something, you can use interlacing to hit crazy resolutions like 2560x1920i, and then use a fractional frame cap (like 40fps at 80hz). That's the only situation I think interlacing is worth doing

That said, if you're not CPU limited and the game's frame rate is uncapped, I think 1024x768 @ 85hz or 960x720 @ 90hz is a better way to go, since they're a bit closer to 1:1 ratio for pixel:phosphor triad. The resolution you gain in motion from the extra frames makes up for the loss in resolution per-frame

Just make sure you're always using vsync and make sure your GPU is keeping that locked without dropping frames. That's the key to good motion. Some new low lag vsync options are scanline-sync in RTSS and latent sync in Special K

2
CommanderBlueMoonOP•

Thank you for the tips. How about simply in normal usage, like watching videos? Right now I have my CRT at 1440i at 90 hz for daily browsing.

1
DangerousCousinLaCie Electron22blueIV•

I would never use interlaced for browsing. The combing artifacts and subtle flicker would get to me.

Video, I guess you could use it since browser based video players are bad at downsampling. High interlaced resolution would allow you to run higher bit depth video like 1080p or 1440p with smoother gradients

But for desktop usage, I'd use 1024x768 @ 85hz on that monitor. Smooth progressive video, clear and crispy text even when scrolling

3
CommanderBlueMoonOP•

Interestingly enough i can’t detect flickering or combing, which I am assuming are the little lines that can appear in interlaced resolutions. 1440p fixes the scaling across windows and websites as well. I was using that resolution before I switched over, too.

I just can’t really notice a giant difference with the actual crispness of the display, which make sense given what I’ve learned.

1
DangerousCousinLaCie Electron22blueIV•

So 1920x1440i on 17" Dell? I imagine Windows automatically turned on DPI scaling

2