Questions about upgrading to an all metal hotend.

Running a qqs pro and want to start using stronger materials on my printer, do I just need a bi metal heat break or are there other parts I need to upgrade? I know i need to run different software but thats about it

Posted Jun 28, 2022, 10:33 PM UTC

11
Rich-Tangerine4452•

With the FLSUN Super Racer, you can use any heat break made for the Creality MK10 hotend, or purchase on the bi-metal heat breaks listed below.

Flsun-Super-Racer-Effector-1

They will all fit the stock FLSUN Super Racer stock hotend, and will greatly improve the performance of your hotend, especially if you’re using the stock bowden setup.

Slice Engineering Copperhead C-E heat break

Trianglelab Bi-metal Heat Break for Ender 3

Mellow NF CR10-TCrazy Heat Break

1
Knowbody42•

A bi-metal heat break is not used to improve strength. It's used to allow you to print at higher temperatures.

You no-longer have a bowden tube going down close to the heat block, which means you don't have to worry about melting it when printing at higher temperatures. However, they use thinner metals in order to prevent heat from rising up, so they can be more fragile rather than less fragile.

1