r/snapmaker•
SmocksT

Buggy Mess

Becoming increasingly frustrated with the integrity of the software/firmware associated with this system and with the support.

  1. My computer won't stay connected, if it connects at all, long enough to transfer a file. My wifi strength is fine on both systems per their own UI. Where are the logs for what is going wrong beyond the unhelpful message "Error: Timeout of 3000ms exceeded"? Do they exist? Am I understanding this correctly that there is no simple way for me to just plug in a flashdrive to transfer my 2MB gcode file? There's no way that's right.... right?
  2. Luban 4.3.2 won't slice anything. It says the model is too small, even if it exceeds the build area. The response I got from support was basically "Oh, use the older version then." ...Really?
  3. My nozzle temperature keeps resetting for some reason. I'm trying to print with TPU and set my gcode file to 230C for the entirety of the job. When the file gets to the printer, it says its programmed for 215C. Using the printer itself after the job is already started to manually change it to 230C works for a few minutes, until it once again changes its own settings back down to 215C. It's not like it just can't get hot enough, it changes the setting itself. What is happening here?

Sorry about the negativity but I'm very annoyed and curious if anyone else has encountered any of these issues and has found solutions, since official support has not been very much help at all.

Posted Aug 6, 2022, 9:24 PM UTC

41
robdirt42•

Which one do you have?

I haven't encountered those issues but wasn't very happy with luban slicer when it first came out and switched to Cura and started getting higher quality prints.

Do you have the firmware on the printer all the way up to date?

Also you can just print from the flash drive and not transfer it to the printer.

1
astromedia•

Agree, they have cool HW but software (and support) is sinking them down :/

I had connection issues with Luban frequently. (tho it could have changed, there is even plugin from somebody for cura to send files to snapmaker and that worked so far and last time I tryed even Luban connected and saw the printer first time which is considering previous experience surprising)

I did used Cura for slicing which worked fine but now with dual extruder they did not provided (or anybody yet) profiles for it so its kinda mess to get it to work - Luban did get some updates but I would highly prefer if they used code from Cura and made their own things over it than trying to reinvent the wheel and wasting time and resources better used at fixing numerous issues users have.

When setting up temperature (atleast now with dual extruder) it does weird stuff from showing -1 as set to heating up unexpectedly to temperature nobody set, ...

1