TsubakiLine•

Loose belts or overheating stepper driver, or something is literally loose on the gantry like the eccentric nuts.

2
FootCallusOP•

By stepper driver do you mean the mainboard? I will check for loose belts. Thanks for your response!

1
TsubakiLine•

The stepper drivers are the chips that control the motors on the mainboard so yes.

2
Roellie88•

While dooing large prints feel if your stepper is getting realy hot. It might skip steps while its cooking. To fix this you can lower vrefs on the mainbord stepper drivers. Most of the time they are to high stock. Lots of yt content how to fix this.

But first look for lose belt or the other easy fixes

2
oathyes•

It was a thing specifically with certain 4.2.2 boards right? If i remember correctly it was around november 2020 that we had a massive investigation thread in the ender 3 sub about the stepper motor drivers overheating after some time and causing a layer shift. I upgraded to a 4.2.7 board and installed a 12mm noctua fan onto the casing to cool it better than the standard little fan and never had any issues.

I really hope its just a lose belt OP.

2
EveningMoose•

What’s the recommended stepper current for each driver? The guide I followed just had me enter factory current values.

1
Roellie88•

I dit set mine on 0.9V. default was 1.1 on mine mainboard 4.2.2

1
EveningMoose•

Voltage != current. I’m asking what current should I set in software.

Or hell, how do I know if it needs to go up or down. “Hot to the touch” is relative, what is the ideal running temperature.

I’m running a dual z, h2 extruder, and have UART to all 5 stepper drivers. I really need to know how to tell what it should be, not what it should be I suppose.

1
Roellie88•

Didnt change anyting in software. Using klipper. I just changed voltage on the hardware . Sorry i cant anwser that for you.

1
FootCallusOP•

By stepper do you mean the motor or the mainboard?

1
Roellie88•

I mean the motor it self. Not the chips on your mainboard.

2
FootCallusOP•

Hey Everyone! I have an Ender 3v2 with a Micro Swiss direct drive and all metal hotend along with a BL Touch installed as well. One of the things that I am noticing after a while is that on prints that are taller I am noticing that the layer shifting gets worse and worse, there is also the globs that form on the print as well. I've included a screeenshot of the GCode if that helps my current EStep Value is also 140.4444444444444

​

My best guess could be something wrong with the Z-Axis but I am not sure where to start. I should also note that I am printing on Inland PETG. Any and all help is greatly appreciated!

1