Hotend fan stopped working after disabling steppers???

Hi everyone,

About an hour ago, a print went wrong, so I disabled the steppers to move the gantry out of the way a bit and get at the print. However, when I did it, the hotend fan stopped and won't run at all.

I've tried turning off and on, manually setting the fan in control, and reloading Alex. No dice. The fan spins freely if I move it with my finger so it's not caught.

Everything else works. I have a horrible suspicion the mobo has popped, but hoping I'm wrong....

Any ideas which wouldn't result in me having to purchase a new mobo?

Posted Aug 18, 2022, 2:56 PM UTC

12
Mik-s•

The hotend fan is not controllable so one of the wires might have come out of the terminals on the board or there is a break in the wires somewhere. Check that the terminal screws are tight and securing the wires.

That fan is connected directly across the 24v supply so if anything else on the motherboard is working then it is fine.

You could test the fan by connecting it to the PSU terminals. Don't use the top of the screws on the motherboard terminals to test as they are aluminium and have an insulating layer of oxide on them so you wont get a good connection.

5

a fan failing is a heck of a lot more likely than a mobo. Start there

3