So i just started print a file sliced in Dremel DigiLab(if that’s important) i have had this issue with another print and it only happens higher on the print, so i don’t think it’s the filament. Any ideas on why this is happening?
(The gap is the horizontal one higher up with some tiny bits connecting it)
Forgot to mention that it happens several times above eachother getting worse everytime. How would i check the extruder? I am new to 3d printing. Is it an issue with slicer? I have the dremel cura based slicer.
So i just started print a file sliced in Dremel DigiLab(if that’s important) i have had this issue with another print and it only happens higher on the print, so i don’t think it’s the filament. Any ideas on why this is happening?
(The gap is the horizontal one higher up with some tiny bits connecting it)
Check the extruder that it has a good pinch and that the gear isn't full of plastic bits.
Possibly check nozzle.
Anyway for those gaps it wasn't able to push filament for one reason or another and then recovered. Reasons may vary.
Forgot to mention that it happens several times above eachother getting worse everytime. How would i check the extruder? I am new to 3d printing. Is it an issue with slicer? I have the dremel cura based slicer.