Nozzle gets increasingly closer to bed during first layer

Posted Oct 22, 2022, 4:36 AM UTC

Posted Oct 22, 2022, 4:36 AM UTC
Hello u/lapotronic,
As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.
Please remember to include the following details to help troubleshoot your problem.
^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.
How long do you let the printer sit at the desired bed temperature before printing? And is your v-core enclosed?
The hot end should be adequately cooled by the fan that’s installed on it, if you’re having trouble you can relatively easily replace or upgrade that fan to help improve cooling. From heat radiated from the bed itself I don’t see why and haven’t seen a post where that’s an issue but you never know. Bigger issue overall would be heating your bed when leveling but your bl touch should do that already when printing. You could just run calibration tool constantly to see if there’s any issues after prolonged heat.
Then your bed is not leveled (trammed) as well as you think it is. It's literally that simple
100% this. It could be the bed or the frame. One of them isn't leveled to each other.
All what they say......it's really really close, feeler gauge or I like a thermal receipt paper and when it goes black and is .just. a little grippy it is right.
Did nobody look at the picture? Look at the layer lines. It started on the right, and goes all the way across the bed before scooting to the left and doing it again.
The beginning of the first layer goes down fine. That part is over 400mm long and is laid diagonally. This is not a bed leveling issue.
This can only be a tramming issue? If there is more to it you need to let us know or we can't help.