r/gridfinity•
Autvin

Easiest way for supportless and/or cleaner magnets (or removing them) using the standard template

Just change parameters.

If you want the holes for the magnets, but they are too messy without supports, then change the parameter "screwTightDiameter" to 0,01.

Now it's too small to get sliced (at least with prusaslicer 2.5) and thus the bridging of the magnet is much cleaner.

If you don't care for the magnets at all, then change "magnetDiameter" to 0,02. Again, to small to get picked up by the slicer.

Neither things mess up the template or cause problems.

​

Enjoy!

Posted Oct 23, 2022, 4:42 PM UTC · edited

41
gltovar•

build a time machine and whisper in Zach Freedman's ear, "Don't forget about support free design"

6
cip43r•

I found it depends on the design, but I don't know yet what causes it yet. I have had prints where the top layer of the holes are printed perfectly horizontally but then others are printed using concentric circles which always fails and requires supports. So depending on how it slices I add or remove supports.

1