r/PLC•
oomchu

Scaling the speed of a VFD for a new gearbox

We have recently installed a new conveyor on one of our production lines. The person who ordered the equipment, but no longer works there, told me he specified a gearbox that was the same as the previous one. After everything was connected, I started the conveyor and it now moves slower. None of the parameters have been changed in the VFD so I'm assuming the gearbox does not match the previous one.

The VFD is an Allen Bradley powerflex 4 which is getting the speed reference from a 0-10V signal. How do I scale this signal on the drive to match the speed I want. It's probably extremely easy, but I've spent about an hour looking online and can't seem to find what I need.

If anyone knows how to do this, please point me in the right direction.

Thanks.

Posted Oct 27, 2022, 1:35 AM UTC

19
bmorris0042•

Since no one else seems to know: I’ve had to do this a couple of times. Figure out the ratio of the old gearbox to the new one. Then change the MAX FREQUENCY parameter by that same ratio. If the old max was 60, and your gearbox is 30% slower, move the new maximum to 86 (60hz/0.7=85.7hz). Assuming the motor can handle the higher frequency, this will do it.

7
oomchuOP•

Ok, thanks. I'll see if that works.

1
robot_mower_guy•

Were you able to get this working?

1
oomchuOP•

Yes. I'm not sure what happened to the original gearbox, but I had a tachometer on hand and changed the max frequency until I got the speed that I needed.

1

There's too much information missing to give you a concrete answer.

If I was you, I'd find the old gearbox and compare the ratio to the new one.

But the gearbox could be the same ratio and the surface belt speed still be different. What you really need is all the information for the drive train. Motor rpm, gearbox ratio, and what size sprocket, or what is actually connected to the conveyor belt and calculate what your new max speed is in your desired units.

Good luck.

4
despicable_dan•

There are lots of names is right. Check your basics first before getting fancy.

If you do need to get fancy, it's a matter of finding the speed/velocity command to the drive, and manipulating it to get the speed you want.

Could be as simple as multiplying the original speed by a factor of 1.1 or whatever will lead to the correct speed.

1
supergenkibear•

Check the manual, it's easy to to look up. If you're trying to change conveyor speed, change the frequency of the drive.

1
controls_engineer7•

Assuming the gear box is actually the exact same....Who and where is the 10 volts coming from?

1
Best-Pollution•

Most VFDs have a +10v and 0v with AIs for potentiometers since it’s so popular to do remote speed reference

1