Scrimroar•

i like the other commenter's suggestion but here's another in case you struggle: you can bring the white strand back into the white section above it and then finish it from the front carefully using a pinhead stitch. it will be barely visible because it's nestled along the weave. then you can draw your thread back into the between layers. good luck! the stocking is really special and beautiful.

8
circusrabbitOP•

Pattern is Sky High Santa by Satsuma Street on Etsy.

This stocking is for my daughter, stitched by me, sewn together by my mother and lined with a velvet top my grandmother (mom’s mom) used to wear, and who my daughter is named after.

When my mother brought back the FO I noticed this thread had pulled out. I preferred the look of one long thread instead of backstitching into smaller sections, and the risk was it pulling out, as it has done here. The stocking is already lined so I can’t get to the under side to reattach. What should I do? My mind says to just go through the lining and anchor it with a knot, but that will fix the lining in place. Am I making sense? Basically the lining is just another stocking inside this one, sewn together at the top.

Would clear nail varnish be ok or will that stain the fabric/make it shiny?

3

Very cute! Could you try burying it like a quilter’s knot? Tie a small knot about where it would be on the underside - not so big it won’t pull through the Aida, but just big enough to resist being pulled out again. Then thread your needle, bring it down to the backside of your work (between the Aida and the lining), pull gently until your knot pops through to the back, and kind of travel by feel to come up through the front side. As long as you travel farther than the length of the thread it will remain tucked between. I hope you find a solution that works for you!

3
circusrabbitOP•

Thank you, I’m going to try that!

1
SissyFrisco•

Hi OP!

You did a beautiful work stitching this stocking!

I completely understand you wanting to have the long string rather than backstitching.

I see you have already received good advice on how to reattach so I don't have anything on that front.

I do want to share with you a surprisingly easy stitch in the event you come across a similar situation in the future you can try.

Couching is a good replacement for backstitching when it's a long continuous length of thread. Typically you use a short pinning stitch across the long thread to hold in place. Often though that short pinning stitch is very visible kind of creates a divot imo.

I happen upon a Needlepoint shop last year and noticed that in a completed piece for sale that the pinning stitch was put in at an angle rather than straight across. To my delight it made the pinning stitch effectively disappear.

I understand sometimes the pinning stitch in Couching is meant to be seen but it's cool to see how slightly changing the pinning stitch can make a huge difference as well.

2
circusrabbitOP•

Thank you, I’ll look it up 😄

2

My mom Made one of these for my two kids and for me 28 years ago. She passed away just after Christmas that year. We still use them. They last. I bought a spare for any visiting famy/ guests, and we used the spare this year.

2