Bio2hazard

Hey,

First off I'm sorry I can't post my workflow right now since I'm at work, but I'm hoping I can provide enough information and context to learn more about what is happening.

So my usual workflow involves a first KSampler pass with a resolution of 832x1282 (could be getting the exact values wrong but thereabouts). Then I pass the latent output from that into a common upscaler convenience node. It performs the vae decode to pixel space, applies a upscaled model (I typically use a 4x yandere, remacri or ultra clear) and vae encoded and then scales it to 0.5 using bilinear.

So far so good, and to be clear this process works fine with zImage. The problem appears when I pass the upscalin

I was very excited for the Eon but once I got it I found the detent unbearably stiff. It takes so much force that it leaves a visible dark red / blue mark on my index finger.

Of course it fades after a minute or so, but after gritting my teeth and bearing it through 50 flips or so trying to break it in my finger is now bruised and I'm pretty sure I'll wake up with a blister on my finger tomorrow.

And to be clear, I am well aware of lockbar sensitivity, so I do make sure I'm not pressing in on the lockbar when flipping - I'm a lefty, so I can see the lockbar when flipping. Also this is not my first frame lock knife.

I did disassemble the knife, clean it out and put kpl on the pivot and be

Mason's passively gives +100% bonus exp for all pilots.

I didn't check the ability tree's and just played as star fox. Now I wish I had started with Mason just to make leveling for other pilots faster.

Was engaged in a fight with a mirelurk, went in for the V.A.T.S. kill.

https://www.youtube.com/watch?v=1QfrOPicNgI

Not the result I expected. I was standing there befuddled for a few seconds after the fact.

No audio because I was listening to the radio, causing twitch to remove it. :(