
CapableProfessional
u/CapableProfessional

3D printed stand built around the KoilBoi flare and flongs with the Sneaky Pete Globe XL, all joined by neodymium magnets!
reddit.com/gallery/13nd85y3D printed stand built around the KoilBoi flare and flongs with the Sneaky Pete Globe XL, all joined by neodymium magnets!
reddit.com/gallery/13nd7rh3D printed stand built around the KoilBoi flare and flongs with the Sneaky Pete Globe XL, all joined by neodymium magnets!
reddit.com/gallery/13nd7cq3D printed stand built around the flare and flongs with the Sneaky Pete Globe XL, all joined by neodymium magnets!
reddit.com/gallery/13nd6gaWhat started as regular clogs, led to a hotend replacement, led to a bricked plastic mess encompassing the thermistor wires. Now I've got all this replaced, working fine for one print, and what happens? The PSU inexplicably dies with no warning. I'm about ready to replace the entire unit instead of continuously putting bandaids on. Anyone else with similar continuing issues?
replaced my hotend and thermal cabling yesterday, since the i got print going, but now the Y axis no longer homes itself, and the steppers will grind if the plate isnt where it expects it to be. anyone know what might be the issue?
GF is looking to get into the life, but is tight on $ right now, looking to see if theres anyone out there looking to dump a spare for cheap

![[H] Pax 3, silicon sleeve, concentrate cup, half pack lid and smell proof container w/storage [W] $130 OBO](https://i.redd.it/wn492y4zysg51.jpg)
![[H] Simrell short with to tip and cap, doob tube and simrell mighty adapter [W] $180 for everything PayPal G&S](https://i.redd.it/c0ey5xyfkg751.jpg)