Easytype

u/Easytype


r/AskElectronics•

Hi

I am working on a solar powered RP2040 based project that is designed to be flown on a small balloon. This puts big limitations on the weight an operating temperature so a battery is out of the question.

The problem I have is that the power-up process on solar is going to be a gradual one, with the wattage from the panels slowly increasing as the sun angle increases at sunrise. The RP2040 does not react at all well to this and reliably goes into an unstable state unless sufficient power to run the board is supplied almost instantaneously.

What I need to overcome this is a component that will block all current from the panels until a threshold voltage of around 3v is reached. is there s

16


r/needamod•

I took on r/ArduinoHelp as an abandoned sub some time ago but I’ve found myself using reddit less and less over the last couple of years and I think the community deserves someone a bit more dedicated to be quite honest.

The sub is intended to be a friendly and helpful environment in which arduino hobbyists can seek help with their code and other issues. Emphasis here is on the friendly part as I have found the main arduino forums to be extremely abrasive and unapproachable, especially for beginners. It is a small community right now but I think it has good potential for growth with the right people in charge.

Looking for someone hopefully with some arduino knowledge or at the very least s

36

r/dji•

I’m probably just being dumb but I’m finding the binding and validation process to activate my care refresh service really confusing.

As far as I can tell I have bound the controller and the drone to my account and I can see both under device management.

When I click on “Value added service” I see the SN of just the controller and a message that says “Connect your aircraft and bind your aircraft to a remote controller to validate DJI Care Flyaway Coverage”. What I can’t work out is whether this message is just for information and shown to everyone or if it’s telling me I still need to do something. For what it’s worth the screen I’m talking about looks like this https://i.imgur.com/ZrJfUsL

21

r/ArduinoHelp•

Hi all

I stumbled upon this sub while searching for a friendly forum where inexperienced Arduino users can seek advice with their projects.

Maybe I'm being over-sensitive but I have often found some folks on the official forum to be unnecessarily rude and openly hostile to those they deem unworthy of their time and this sub looks to have been set up as a far more approachable community.

It was therefore a shame to see the sub was abandoned and restricted to approved submitters only and as such I have taken on this subreddit through a request to r/RedditRequest and removed posting restrictions.

For my part I will try to run the sub in the spirit that I believe it was set up, and on that

31

r/Ratched•

Is anyone else having issues with the frame rate on Ratched?

I don’t know if it’s the fact I have the 4K Netflix package or if it looks like this for everyone but the frame rate is noticeably too high on this show, which consequently makes everything look like a promo for a cosmetic surgery clinic.

I’ve turned off all the motion smoothing options on my TV so I’m assuming this is how it’s supposed to look.

I’m quite enjoying the story but I’m finding the visuals are just distracting and make you feel very aware of the film crew on the other side of the camera if you know what I mean.

Edit

Just to follow up on this, I have fixed the issue. Seems on my Samsung TV you have to disable “Auto

13