Grevin56

I have a Creality CR-6 SE on the most recent community firmware installed. All of the different masks I've attempted to print recently have started failing after around 60mm of height. I thought it might be the hotend not heating properly and causing under extrusion so I replaced the factory one with a Microswiss hotend with a fresh 0.6mm nozzle. After that I calibrated the PID and E-Steps and leveled the bed. I used a fresh spool of filament for this attempt after dehydrating it for 16 hours. All prints sliced with Cura 4.11 and no matter what filament (PLA or PETG) or settings I use the same thing keeps happening, any advice would be greatly appreciated.

https://preview.redd.it/iv5hjh

I'm looking for an active casual guild for myself and my girlfriend. Right now we have level 20 characters but we are veteran MMO players. Our main focus to start will be PVE. Looking to play with other adults, sorry but I'm not good at watching my language.