LearnYourMap

Hey there,

I need help with my Ender 3 v2, I printed a simple one layer level test to see if I did the bed leveling correctly. But, the four circles on the side look good, but the one in the middle doesn't. I even bought some more clamps to make sure the glass plate is pressed down enough. But it didn't help.

I use Cura, PLA

• Ender 3 v2 & Cura
• PLA XINGTONGZHILIAN
• 200 for nozzle and 60 for the bed
• Print Speed (default settings)
• Nozzle Retraction Settings (default settings)
• The only thing I changed I am printing at 0.12 layer height, as the disc are too thin otherwise

Can anyone tell me what I can change so that the whole bed is level, whenever I print something in the m

Hey AC Lovers,

I am searching a few certain flowers. I pay very well:

Blue Roses: 20k per flower Purple Tulips: 15k per flower Purple Windflowers: 10k per flower Green Mums: 10k per flower Purple mums: 10k per flower.

I am also willing to pay in nmt.

If you have any of these flowers, I would appreciate it.

I would also water your flowers, if you want.

If you have one of the flowers but are unhappy with my suggested prices, write me anyway.