Levistor

u/Levistor


r/SwitchPirates•

Hi, I have been trying to increase FPS on some games (TOTK, Sifu etc.) I am applying different settings on sys-clk but it doesn't go beyond 30 FPS.

Do I need to use software like FPSLocker on top of sys-clk in order to get higher FPS ?

19

r/SwitchPirates•

Hello, I recently got a hacked switch OLED and loving it so far. I have been using ultranx site to install games. I have played through prince of persia:lost crown but it's missing DLC. Now I am trying to install DLC on top of my existing game. How can I do it ?

06

r/digimon•

I am a fan of the franchise but I have only played online digimon games like Digimon Battle Online and Digimon Masters Online back in the day.

Time Stranger will be my first singleplayer digimon game and I am kinda baffled about digievolution lines.

I keep looking at people's chart in this sub and see things like dorimon can evolve into 4 different rookies ??

What is the logic behind this design choice ? Why not make it more linear especially since many digimons already have established evolution lines ? To give more freedom to players ?

014


r/short•

I have been wearing Nike air max 95s ( it adds 1.46 in) which puts me at a height that I feel comfortable but it kinda feels like fake height ?

What would you say the average shoe height that people wear these days is ?

28

r/beatsaber•

Hi, I recently got my quest 2. Loving the game so far. I would really like to know if there are any ways to reduce visual effects and clusters to make it less eye straining. I already activated the night mode.

85

r/ender3v2•

Hi, I have installed a bl touch but I dont quite get what is happening. So what I do is:

1- Manual level the bed

2- Adjust z offset with a calibration print

3- Save previously used z offset

4-Create new mesh

4- Print exact same calibration print

But after that nozzle is too high and doesnt stick at all. Am I supposed to not create new mesh after saving z offset ? I have added the m420 s1 code btw but not g29.

27

r/ender3v2•

Hi, I am using a bmg v2 extruder from trianglelab. I sometimes hear a clicking noise but if I tighten the screw it goes away.

Is it supposed to be very tight ? Right now I almost cant manually pull extruder arm.

21