LinearFluid

So client of mine droppingbcable and picked up Starlink. They ordered the home Max. They chose to buy the hardware and not rent. They got the Mini Kit V5 abd not the older kit. I was not aware of this existing fresh out July 26 and expected them to get the Standard V4 like a client just got 4 months ago. Doing the same thing a max sub.

I am not sure if this latest is the greatest.

I had another post about which mesh to go with Starlink or 3rd party.

Everything I see says the V3 router UTR-232 is better. I am trying to figure out if they should buy the V3 router since they need mesh and place that as the main router and then use the Mini as the mesh node. If even possible ?? or get anoth

My birthday this month. Was offered a onetime 10c off gas. I waited til I was empty empty. I use Google pay for all transactions. Set to credit card. I keep no money in checking aand put in when needed. My phone does not shutoff sometimes when going into pocket and screen get pressed just by fabric.

Well it seems after a transaction and putting it in pocket presses my card defaulted to my debit and not the CC card. So my debit account had little in it and cut off at that amount which was less than half a tank. So now since I waited when I filled up last time I use it, I got less discount than if I had used it then.

I can't get the little win.

New setup for a client should they go with OEM or 3rd party?

Second I see if using third party I see an instruction says enable Bypass.

Bypass as I am familiar with is bypassing original router and setting it in Gateway and using your own router as well as Mesh APs.

Do we bypass or just disable WiFi on the starlink if 3rd party mesh?

So we will get sometimes between cooks in the humidity the pellets fall apart and clog the auger.

But it really does not clog the loose sawdust just does not produce enough mass and heat for the system to see it as working and then goes into shutdown turning auger off and the burner off while still being on.

Clearing this I have found having to turn it off to reset and have the auger prime which is short so have to do this several times. I can't keep tearing the hot grill apart to get to the cup to put a handful of pellets in it.

Solution is simple .

There should be a purge cycle that you can invoke that say, turns the auger for 10 seconds while using a higher feed rate.

Simple and need

Parked, locked the X. Came back, fob was not working. Put key in driver door. Turned it and just got a click from the rear driver passenger door area every time I turned it. The hatch I could not even turn the key.

Went inside for a minute to call for locksmith. Trouble getting locksmith. Came back to car as Ai walk up I hit the key fob and it unlocks. What the heck went on here?

That is all. Stupid kids doing stupid.

I am having trouble with the firewall settings. It had a VPN setup before and I redid it. Problem is from the UISP device of the VPN it works and I can see IPs in the UNIFI subnet but from the UNIFI I can not see IPs in the UISP subnet.

​

Sure it is a console problem in firewall as the UNIFI is zone firewall and has another VPN site to site that works.