Merad

Ideally around Hickory, Statesville, or Winston. Would prefer to use someone familiar with firearms engraving rather than any random . I have heard good things about Tarheel State Firearms in Matthews but they're about 90 min from me plus it means driving thru Charlotte (bleh).

Simple question, I hope - when you go to the range, do you take a copy of the entire Form 1/4? Or is it sufficient to just have the first page since it really has all of the relevant info?

First 10/22, I ordered this Custom Shop model kind of on a whim because it's dead sexy. I can't really to be a .22 expert, I have a few plinkers (Marlin 60, Marlin 39, CZ452) and a CZ457 that's set up with a Vortex Diamondback 4-12x40 and Harris bipod.

So... I don't have any specific setup in mind for the 10/22 yet, looking for ideas & suggestions. I have a few hundred bucks in store credit at Optics Planet so anything available from them is a big plus.

I'm doing a barrel swap to the HB tri-lug barrel and the head stripped out of one of the extractor screws. The only M3 x 6.5 I've been able to find online have a philips head (no thanks). Any source for these SOBs? If not do we think M3 x 6 would be alright, they seem to be much more common.