SnowyAlpha

u/SnowyAlpha


r/GMT800•

I have a 2004 GMC Sierra 2500HD, I recently rebuilt the front end suspension and steering, since then i have had an ABS light on my dash yet there were no apparent issues. I then had to replace my brake lines so i swapped out the front wheel speed sensors while i did the brakes thinking the sensors were bad but the issue became worse, if i exceeded 60 MPH the ABS light would go out until i began to slow down, roughly around 30 MPH the ABS light came back on, and if i touched the brakes before the ABS light came back it would activate the ABS and bring me to a stop on its own.

The only comparable problems I've read about others having online are their ABS sensors having rust between them and

15


r/ender3•

Would the fan on the side of the extruded housing being off affect my first layer from sticking

11

r/ender3•

Printer Bed

Discussion

Should I upgrade from the stock ended 3 bed to a glass one?, tell me your opinions and thoughts

14

r/ender3•

I’m asking for help, I can’t get my prints to stick, I’m fairly confident that my bed is level and that the nozzle is the correct distance, but it won’t stick. Also any tricks for leveling would be greatly appreciated.

15

You've reached the end of this feed.