Sufficient-Assistant

I've looked online and couldn't find an answer. I have the S9 Ultra (1TB model if that matters) and it seems that after installing the official Samsung smart book cover case the magnets are throwing off my s pens accuracy towards the edges. Specially the upper left corner, which is super annoying as I use the tablet as a notebook (the s pen is amazing and I love how it writes). Any way to calibrate the s pen so it remains accurate in the edges?

I saw the 1TB version being significantly cheaper and shipped within the US from that store. Anyone know if it’s legit?

Hello,

I have made some modifications (mainly insulation and heatsinks) to my printer. I have covered and insulated the port where the wiring to the bed goes to minimize heat exposure to the motherboard and insulated all sides of the chamber. I can comfortably get the inside to 80C but when I start a print it automatically goes back to 60C. Does anyone know how to fix this? I have changed the printer.cfg file which allows me to go to 80C after the print starts but it does not allow me to start a print at that temperature. I know people are going to say the printer wasn’t meant to go that high. Well I am modifying it to see how far I can go with insulation, water cooling/heatsinks. I may als

I had a K1 and I had to install a second side fan to get adequate cooling and surface finish. I would rather not play with a second cooling fan if I don’t have to. That being said does it come with a second side fan like the bambu printers?

Why does the creality K1 not probe with the hot-end at the desired temperature? I have to keep manually setting the z height because filament leaks and when it does it’s auto leveling? How do I change this? Is it frustrating because I already ruined two build plates. What was creality thinking? How do I change it so at least it probes and does it’s homing above 180C?

How to I turn this feature off? It is so annoying and frustrating because I need to keep them on while printing some PPS otherwise I have to slow down the print by half. Anyone know or has experienced this?

How to I turn this feature off? It is so annoying and frustrating because I need to keep them on while printing some PPS otherwise I have to slow down the print by half. Anyone know or has experienced this?