Syde80

Unofficial results here: http://election2022.thorold.ca/

Mayor:

• Terry Ugulini (incumbent)

City Councillor:

• Henry D'Angela
• Carmen DeRose (incumbent)
• Tim O'Hare
• Anthony Longo (incumbent)
• Ken Sentance (incumbent)
• Mike De Devitis
• Nella Dekker (incumbent)
• Jim Handley (incumbent)

Public English Board Trustee:

• Nancy Beamer (incumbent)

Separate English Trustee:

• Rhianon Burkholder (incumbent)

Separate French Trustee:

• Melinda Chartrand (acclaimed)

EDIT: just fixed formatting

Most a x-post from https://www.reddit.com/r/niagara/comments/xpppfg/im_glad_that_local_politicians_got_their_signs_up/

Somebody was asking for platform info on all of the various candidates, below is a copy/paste of what I was able to dig up incase any here find it useful.

On Oct 6, Port Robinson Proud is hosting a Candidates night at the Port Robinson Community Centre - https://www.facebook.com/PortRobinsonProud/photos/a.670024393044641/5458445847535781/

On Oct 12, NBOTAC is hosting an "All Candidates" event at the Four Points right next door to City Hall https://nbotac.com/event/nbotac-all-candidates-night/

Also many of the candidates have platform websi

I'm not sure if this is doable or just something I can't figure out. Double tagging is not something I've had a need for previously. We are migrating some of our circuits from EVPL to EPL circuits. We have an option of our service provider handing us off a single connection that carries all of the circuits and we need to double / stack tag on our end, our other option is they terminate the EPLs and give us a separate handoff for each circuit. We are only talking about 5 circuits at the moment, so its not a huge waste of ports... but we are likely to add more in the future as well.

We are using EX4600 on 20.2 code.

What I'm looking to do is on a physical interface, define a sub-interfa

I have probably close to a couple dozen Juniper devices included SRX300/340s and EX2300,3400,4600 and using SNMP v3 on all of them quite well.

That is... except for a single SRX300 which I'm about ready to zeroize it and start from scratch unless somebody has any advice. It was working on this device, but this branch site had a sudden change in ISP and we had to temporarily run it off of an LTE connection while the new ISP got put in put in place. That also meant it was behind CGNAT and I had been polling it via its public IP, which is obviously a no-go with CGNAT. However, we use ADVPN so the site was connecting back to HQ and was available via its st0 interface. The only issue there