
TheMathProphet
u/TheMathProphet

Theoretically there should be very little difference in talent between the 30th and 31st pick, but given they are in different rounds the 31st pick gets paid less ($3M vs $1.25M), in addition to other prospects like 2-way deals, etc. So doesn’t that make the 31st pick better than the 30th pick?
Follow-up - which 2nd round pick is the first pick less valuable than 30? Is the 33rd that the Wolves got for Randle better than the 28th?
I was reading a joke on r/jokes that I have seen many times and in the comments you always see “good old #67” or some such. Which got me thinking, we gotta be able to actually number these, right? Pull them all, analyze their history, figure out their origins, and actually number them? Then a bot can be made that would actually post the number below a joke if it knows the number? And God forbid an actual original joke makes it, the bot could celebrate it? Thoughts?
Gets in the game and hits a 3. My man!
By looking on here I have learned that .makerbot is a zipped file with the Gcode and some other things. Can I slice on a different slicer, zip it, then append the .makerbot file type to bypass the Ultimaker/Cura slicer?
I have a second hand Sketch and the native print temp is higher than I want (230/225). I changed the settings in their native slicer and tried the print again but the temps didn’t change. I opened the Gcode file and have verified that the command M104 S215 but the temp doesn’t change. Ideas?
One of my 3D printing mentors wants me to start experimenting with TPU and I’m game. What are your favorite things to print in TPU? What tips and tricks have you learned the hard way? I have a Prusa MK3S+ with enclosure. TIA!
I own 3 Prusa products - 2 minis and an MK3S. I bought them because I was told they were workhorses. My MK3S has had more fails than prints. I have one mini that is still working, but the other one prints like it’s drunk. I have had two people who work professionally with 3D printing try to support me and they have given up. I had a thermal problem on my MK3S and completely replaced the entire hot end, replaced firmware, and scoured the help boards for new ideas. At this point I genuinely believe that I have spent more time working on the printers than the printers have worked for me. Is there any reason this community could convince me to continue with these printers or suggest them to my s




