
clarkcox3
u/clarkcox3

Simple stand for storing Dell micros on a Gridfinity base
printables.com/model/1366686-dell-micro-gridf...Dees there exist a microSD to SD card adapter that supports SD express? Every adapter I can seem to find only has 9 contact pads, so it clearly can't support UHS-II, much less SD Express.
Am I missing something, or does what I'm looking for truly not exist?
I'm trying to calibrate the e-steps on my Artisan, and it seems that I can't get any of the current values (i.e. commands only respond with ok but no further information.)
So far, I've:
-
Used a length of filament
-
loaded it
-
measured the length sticking out from the top of the module (116.6 mm)
-
extruded 50mm: (
G1 E50 F300) -
Measured again (69.8mm). So it's clear that only 46.8mm was actually extruded. So, it's clear that the error is about 7% (i.e. 50 / 46.8 =1.0684 )
-
Then I go to fetch the current value with
M92orM503, but all I get back isok
What do I need to do to fetch the current settings so I can calculate the new value to set?
When I am connected through a tunnel to a remote machine, and I use code somefile in the integrated terminal, the file gets opened in a window on the remote machine (which is, of course, useless if I don't have GUI access to that machine at the moment). What do I have to configure to cause the file to be opened in a window on my local machine?
More info:
- The remote machine is running macOS
- The remote shell is zsh
- Shell integration is activated in the integrated terminal
codewas installed via "Shell Command: Install 'code' command in Path" at/usr/local/bin/code
Should I expect to be able to access my tailnet from non-tailscale devices on my LAN?
- I've got tailscale set up on several devices and all seems to work fine (each device can see all the others and communicate via the assigned .ts.net hostnames and 100. IP addesses).
- I've got tailscale on my Unifi dream machine, and it is set up as a tailscale router and exit node. I can access my LAN devices from my tailscale devies just fine, and I can use the exit node.
- That unifi dream machine is the default gateway for everything on my LAN
However, I can't access any of my tailscale devices from the non-tailscale devices on my LAN. Should I expect to be able to do so? Or is that unsupported?
In the system I’m building, the farthest HDD is about 20cm from the ports on my SAD HBA, while the closest is within 5cm. But the shortest SFF-8643 to 4X SFF-8482 cables I can find are 50cm. This makes cable management a nightmare, as I’ve got so much slack to account for. At some point, it feels like I’m just mashing cables in.
Does nobody make shorter cables?



