dangle227

Could someone please point me in the right direction.

I have 3 outlets in succession in my dining room (2 on one wall and 1 on a perpendicular wall) that have stopped working.

What I have tested/know:

1. None of the outlets are attached to a gfci breaker outlet / there are no tripped gfci outlets in my house.

2)No breaker on my box is tripped.

3)I have pulled all 3 outlets and tested the wires. There is no power coming to the wires.

I am at a loss on what else to test. I assume the outlets are not bad, as the wires are not getting power. Any help is appreciated.

My wife shoots food photography with a D3400 but she says it’s hard to view on her camera to see what she needs to adjust. I would like to figure out a way for the photo she takes to immediately show up on an external screen. Preferably I would like to view it on an iPad as we have one just sitting around. I don’t think she would mind if she had to hook up with a usb cable. I was looking at digicamcontrol but it’s not available for iPad. If this is the best option, we do have a laptop we can hook up to. Any help or point in the right direction is appreciated.

About a week ago I roasted some red peppers, sliced them up and submerged them in EVOO with some sliced garlic and dried oregano for some Italian sandwiches.

I left that in my cupboard for roughly 5 days and it was VERY active. I have since put them in the fridge. Do you guys see any reason why this could be harmful to eat?

Not new to 3d printing, but new to upgrades that are not printed.

Ender 3 (Non Pro) V1

Used the Bin file : Ender-3-Marlin2.0.1 - V1.12 - BLTouch - TMC2225.bin located in their Ender-3 4.2.7 mainboard(32) zip file.

Just installed the creality v4.2.7 silent board and a BLTouch. I ended up plugging the 3 and 5 pins from the BLTouch into the 5 BLTouch port on the new board, which works as the BLTouch is probing the bed, but the nozzle is entirely too far away from the bed.

I have walked through the "Platform Adjustment" directions included with the BLTouch for the 32 bit. The issue is that when I probe the z offset, I can't get the nozzle close enough to the bed to catch a sheet of paper.