debaterOfMath

Sithilis

Anyone know where to get one in UK?

I've had no luck so far, has anyone managed to get their hands on one of these bad boys?

I've done 1 print in kisslicer and its immediately obvious there are some significant improvements. Primarily blobs are greatly reduced, hole sizes are much more accurate, support material infinitely better and pathing isn't retarded.

Anyone had similar experiences? I've given slic3r a decent chance but now I've jumped ship I don't understand why the majority use it

Whats your go to supplier for motors, gear heads, encoders, bearings, or just anything robotic? I've been browsing mcmaster.com which is great but is missing some essentials.

Hey, my Pajero electrics started getting all buggy and eventually stopped working and I measure a voltage drop to about 4-6V when turned key to ACC or ON. Battery is fine as can turn the starter over, also can clutch start but it seems to me that I have some electrical short. I took apart my ignition switch cylinder and have continuity to chassis when ACC / ON (dw I disconnected battery first). Does the Ignition switch have a GND wire because my Black/white wire is about 5Ohms to chassis.

Any ideas / any1 got any idea what I can find a 1995 wiring diagram?

Hi, I'm programming a pic32mx220f32D and have unfortunately run out of Kseg0 prog memory. In the manual it says that kseg0 and kseg1 RAM and PROGRAM sections are programmable. Firstly how could RAM be programmable and why would you have uncached RAM (Kseg1)? and if you have experience with how this is done could you assist?