u/eclipsev1
I wasn't successful in modifying the shapeways plate so made this from black perspex. Not a perfect job but a good press fit so no need for the screws.
I have a charcoal panel set that VapourDepot say will be arriving soon so should look ok with that.
Just started to do some improvements to my Cloudmaker. I’ve swapped the Varitube 510 for the Evolv reference 510 fitted in the centre position. Replaced the stupidly long output lead and bullet connector from 300mm to about 40mm by taking a direct route. This has halved the mod resistance. I also stripped off most of the plastic stocking from the cables.
I need a centre hole top plate to finish that off, I’m not a fan of shapeways 3D printed stuff but have ordered one from them, reckon I’ll end up looking round and make something better myself.
I’ve removed the ‘X’ bracket and battery holder and made a couple of corner mitres which makes room for a larger battery or a 18650 sled. All of
I ran battery analyser and the result was 10.611Wh which makes the battery capacity 955mAh about 13% less than advertised. Anyone else done this.
You've reached the end of this feed.
