failburt

u/failburt


r/Hewlett_Packard•

I have an HP Spectre x360 13-ae088ca bought second hand. When shut down, Windows goes through all the motions and the screen turns black but the led status light on the power button remains on. If I put it away in this state, it stays slightly warm and runs down the battery. To avoid this, I can press and hold the power button for about 6 seconds until the LED turns off.

Asking Windows to Hibernate also has the same issue. Windows will hibernate, the screen will turn black, but the status LED stays on and the laptop will run down its power. I can press and hold the power button to cut the power and when I turn it back on again, Windows resumes from hibernate like normal.

I have applied the

14

r/MarvelSnap•

I accidentally bought a variant with gold when I was trying to X out of it.

I didn't lift my finger quite enough when positioning my hand from the center of the screen (the place I tapped to look at the variant in detail) to the bottom of the screen where the X button is. Unfortunately, in that motion I activated the buy button that is placed directly in that path.

As much as I'm sure they don't want to add friction to spending money, it would be bad for them if browsing the shop feels dangerous.

01

r/EVGA•

I'd like to buy an EVGA GeForce RTX 3070 XC3 ULTRA GAMING but I already have a PCIe card in the slot two spaces from where it would plug in. Will installing the XC3 Ultra, a 2.2x slot card, in the first slot collide with a card in the third slot? Is that 0.2x overage usually a problem?

31

r/homeowners•

I found my furnace room floor was wet. It seems like air conditioning condensation was leaking where it shouldn't be.

There is a pipe sticking out of the ducting with a rubber hose leading to a floor drain which I guess is the intended path for this water. But there is also a second pipe sticking out that is capped with a little red plastic stopper. The water was dripping out of there and also from a random corner lower down that has been sealed up with silver tape.

I took a picture for you to see here: https://imgur.com/a/8dFjh84

I removed the red stopper and a significant amount of water poured out. I'd estimate somewhere around 1/2 to 1 gallon. It seems to just be pooling inside and no

12

r/vagrant•

I'm trying to use snapshots for the first time. I took a snapshot and then I did a vagrant destroy command to try another configuration. I'm now trying to restore my snapshot but it can't be found. Did I delete it when I did the vagrant destroy?

Is there somewhere I can copy a snapshot to so that I can restore it after a vagrant destroy?

13

r/HPReverb•

I just wanted to add a post saying I got a new cable from support without too much hassle.

I ordered my unit from HP Canada in September 2021 and got a v1 headset with a v1 cable and didn't have any problems with my b450 based system. I recently switched to a ROG STRIX B550-I GAMING motherboard and started getting the 7-14 error so I used chat support and explained my problem. After running through their troubleshooting steps they sent me a new cable overnight.

One kind of laborious thing in the troubleshooting is to try updating the firmware of the headset. However, the update software cannot detect the headset if you're having the 7-14 error so I tried it, saw the software could not proc

73


r/Ubiquiti•

I'm having issues with my home network. I'm suffering short internet disconnects (1~3 minutes) multiple times per week with a UDMP and I need help with where to begin troubleshooting.

I have recently factory reset and readopted everything in an attempt to "start fresh" but the outages continue to happen. I'm now running the following versions but the problem has been happening for 6+ months:

  • UniFi OS Version 1.11.0
  • Network version: 6.5.55
  • Protect version: 1.20.3

The basic indicators seem fine:

  • CPU Load is Low (28%)
  • CPU Temp is Good (42C)
  • Memory is 2.01 GB / 4.04 GB (49.7%)

There are about 30 active clients on my network and these are the Unifi devices on my network: https:/

16

r/buildapc•

On a new install of Windows 10, this popup from Asus appeared and offered to provide the network driver for my Asus motherboard.

How does this work? Is my motherboard providing the popup to the OS for it to show me? Is the popup something that's part of every Windows installation but only gets activated if an Asus motherboard is detected? Something else?

22

r/chia•

After a certain point, it becomes kind of tedious to manage individual drives. I think my patience ends at around 10 drives.

How are you managing 20, 50, or even 100+ hard drives on the software side?

I've love to hear what others are doing to help me decide. Did you make sure to get matching drives to make an orderly ZFS pool? Did you skip the cost of parity drives because plots are among the most replaceable data there is? Or are you actually still managing individual drives and run out of letters in the alphabet for drive names long ago? Did you set up mergerfs to help manage the mess?

231

r/homelab•

I've been thinking it's time I tidy up my home servers from a collection of PC towers to a few chassis in a rack. It'll be awesome! I even bought my first rackmount equipment, a Netapp diskshelf and it included four power supplies and four 1ft C13 extension cords. This got me thinking how am I even going to plug everything in? So, I've done some reading online and I've got a few points I could use clarification on. I was hoping I could get some help from people who know more about it all than I. Thanks!

  1. Rack mount UPS's seem to cost 3x what a [desktop model](https://www.amazon.com/APC-Protec
39